Easy foot shears

Since the foot is human-powered shears, so the use should pay attention to the following points; cold [1], this machine can only be used at the clipboard 2mm material thickness, width below 800mm to 1200mm, Hot-rolled steel and aluminum shear. 2, the machine prior to use, the components of the machine must be adjusted, and the moving parts as stringent checks. 3, the machine must be kept clean, in the painting and the sliding part must be coated with anti-rust oil. 4, cutting edge blade on the machine should be kept sharp, if found damaged or worn and blunt lag phenomenon, should be rubbing and exchange. 5, the machine moving parts should use clean, non-corrosive and debris objects, often lubricating agents, maintain a flexible machine. 6, in strict accordance with operating procedures to cut, do not overload the machine to withstand overload cut, in order to avoid damage to the machine parts or blades. 7, when the cut if there is an abnormal phenomenon, should immediately stop cutting, adjustment and maintenance. 8, in the cut sheet metal of different thickness, the upper and lower blade edge cutting blade gap should adjust, adjust the ratio of the gap is 1: 0.03 mm. For example: When the cut sheet thickness of 1 mm, the upper and lower edge required for the 0.03 mm gap.