Beijing Beijing adhesive binder stone tile adhesive tile adhesive manufacturer Beijing

 JY type adhesive Hu Yongfeng: 13611272094 010-57117047 Features This product is a polymer-modified cement-based special binder, operating performance of its construction, the bonding properties than traditional cement mortar has greatly improved. No need to dip brick, construction fast; thin construction, reduce weight; strong bond, easy hollowing; non-toxic environmental protection, weather resistance, water resistance. Usage ◎ JY-101- special ceramic tile adhesive: Suitable for indoor, wall and floor ceramic tiles paste, wipe the surface can be used for waterproofing membrane protection layer. ◎ JY-102- tiles special binder: Suitable for indoor, wall and floor tiles paste, whole body bricks. ◎ JY-103- marble, mosaics special binder: for interior, exterior and thin paste of ground marble, large pieces of stone, granite, polystyrene board, extruded sheet, rock wool panels. The use of the binder can be widely used in concrete mortar walls, floor and wall surfaces on all types of tile adhesive. Key Features 1, high bond strength; bond strength is about 2-3 times the pure cement. 2, good construction performance; this product has good water retention, anti-flow fall time adjustment of up to 20 minutes. 3, cost savings; As the adhesive powder belongs to thin bonding, can greatly reduce the amount of cost savings. 4, good durability; this product has a certain flexibility, due to the thin layer of adhesive, enhanced ability to resist deformation, has good durability. Using the methods and precautions 1, primary treatment: the grassroots level requires a solid, free from dust, loose layers and oil, large voids to be pre-patch. 2, slurry preparation: The tile adhesive powder slowly adding a certain amount of water, water-cement ratio of about 1: 4, while adding while stirring to a suitable consistency so far, standing 5-10Min then stir to use, Note that in the slurry formulation can not be formulated too much time to run out before the initial setting as well. 3, tile adhesive: the stirred slurry was applied on the substrate with a toothed trowel, making and dressing the striped uniform, in order to exclude the air, in the back of the tile thin layer of slurry scraping the tiles the entire back of the tile adhesives completely seal can not be left blank seam. Before the tile adhesive generally does not require pre-soaked wet, just to clean the tile surface topsoil. 4, pointing, cleaning, and the same as the conventional operation process, but to ensure pointing dense, full and smooth. 5, the thickness of the material varies due brick, marble general: binder should be 5-7mm; tile: binder should be 3-4mm ,; tiles: the binder should be 5-7mm; 6. Dosage: per square meter The adhesive paste per millimeter thickness is about 1.7 kg dose. Note clotting time and a variety of factors (temperature, dryness) is generally the initial setting time of 5-6 hours, final setting time of 24 hours, before driving the vehicle after the bond Plaza week, not construction when it rains, the construction should 5 ° C and above. Packaging, storage and transport 1. Packing: packed powder 25kg ± 0.5kg / bag. It should be stored in a dry, airy environment, waterproof, anti-sweat, unopened shelf life of six months, according to general cargo transport. 2. This product is non-toxic, odorless, non-flammable, storage and transport according to non-dangerous goods Contact: Hu Yongfeng Mobile: 13611272094 (Beijing) Telephone: 010-57117047