Import PSU board, translucent PSU board PSU imported material reports

Import PSU board PSU board translucent imported material reports import PSU PSU board PSU board translucent imported material reports import PSU PSU board PSU board translucent imported material reports import PSU PSU board PSU board translucent, import PSU PSU board imported material reports, translucent PSU board PSU imported material reports import PSU board PSU board translucent imported material reports import PSU PSU board PSU board translucent imported material reports import PSU board PSU, PSU translucent panels, import import PSU board PSU material reports, translucent PSU board PSU imported material reports import PSU board PSU board translucent imported material reports import PSU PSU board PSU board translucent import import PSU board PSU material reports, translucent PSU board material imports PSU Report, polysulfone high amber transparent solid materials, hardness and impact strength, non-toxic, heat-cold good resistance to aging, long-term use at -100--175 degrees. Inorganic acid salt corrosion resistance, but the impatience aromatic hydrocarbons and halogenated hydrocarbons. Polyarylsulfone high hardness, resistance to radiation, heat and cold resistance and self-interest, long-term use at -100-175 degrees. 2, through a glass fiber reinforced modification can significantly improve the wear resistance of materials. 3, polysulfone and ABS, polyimide, polyether ether ketone and fluorine plastic, etc. made of polysulfone modified products, mainly to improve the impact strength and elongation, solvent resistance, resistance to environmental properties, processing performance and electroplating. Such as PSF / PBT, PSF / ABS, PSF + mineral powder. 4, polysulfone [1] can be used continuously at 300 ° F steam. At 180 ° F water, maximum pressure of 13.8MPa (static load) and 17 .2 MPa (intermittent load). In order to maintain long-term transparency and impact resistance constant at 180 ° F in water, the maximum pressure is 3.5MP (static load), 6.9MPa (intermittent load). The lower the water temperature, the higher the under pressure: for example, when 72 ° F, maximum pressure of 20.7MPa static load), 24.7MPa (intermittent load). 20.7MPa pressure at room temperature, after 10000 h, polysulfone creep (strain) is only 1%. Under stress 210 ° F, 2.07MPa, after one year, the total is still less than 2% strain. 300 ° F after long-term use, polysulfone strength and modulus increased by 10%, 90% to maintain dielectric strength, impact strength retention of 70%. Polysulfone tensile impact strength up to 200. When exposed to high temperatures in the beginning months, such as 300 ° F will have an annealing effect can be reduced 30% of property value. But these properties are held constant at two-year test period. 5, polysulfone has good overall electrical performance: Despite the low dielectric constant and dissipation factor, but still has a high dielectric strength and volume resistivity. And can be kept constant over a wide temperature and frequency (even microwave frequency) range. Polysulfones can be nickel and copper electroless plating and having a 20lb / in bond strength.