Pressure the ball machine to factors that affect the rate of ball

 Pressure the ball machine equipment supply must meet rationing supply, variable speed screw conveyor can also be used to observe the return quantity adjustment of the supply amount of new material. Enter dome control the particle size of the material should be less than 1 in 30 to 40%; 1-2 material should be 30-40% of the particles should be less than 3 largest particle should be around 10%. Binders and other additives (such as sulfur removal agent) user credentials and use the environment to conduct its own coal preparation process (to be negotiated by the supply side). Material into the dome opposite does not allow iron or other high hardness so as not to damage the piece of debris ball press machine equipment rollers and shafts, using department should be installed in addition to the iron part in the process of formulating. Into the pressure ball machine equipment material moisture control in 8 to 10% material moisture should be strictly controlled, to control the position of the general in a blender. The material is too dry, when pressure the ball, prone to the phenomenon of the two hemispheres and crushed the ball; the material is too wet, likely to cause pressure ball machine ball caked material not stuffy vehicle phenomenon ball and pressure the ball. Usually when a ball pressure ball machine water: binder using lime and clay molding when moisture is 18-20%; binder using pulp or rot value when the water is 10-12% acid forming; use composite stick When coalescent forming moisture 11-13%: the use of asphalt binder forming a moisture content of 2-4%; without binders young lignite moisture 12-18%; no binders weathering anthracite extrusion When the water is 15-18%; no adhesive powder molding moisture less than 2% of granulator: http: //www.lingruizz.com/ mixer: http: //www.lingruicn.com/ pressure ball machine: http://www.zhiqiuji.com/ Phone: 13140158782,0371-86595263,15503714627