Factory direct T8led integrated constant current 1.2 m 96 0.2 watt lamp beads, high brightness

LED fluorescent product is used for offices, classrooms learning. Fluorescent lamp is now the preferred energy source of building energy efficiency, compared with ordinary lamps, saving up to 80%, the service life of 5-10 million hours, for offices, shopping malls, restaurants, factory workshops, factories, schools and so require high brightness lighting occasions. T8LED fluorescent characteristics 1, low-light failure. 2, switch without delay. 3, high efficiency, high power factor of the photoelectric conversion constant current drive system. 4, the light source using the most advanced ultra-low power, ultra-bright white LED. This product uses the latest semiconductor light source technology, saving up to 80%. 5, power supply no flicker, this lamp life 10 times more than ordinary lamp, almost maintenance-free, there should always replace the lamp, ballast, starter problems. 6, energy-efficient, ultra-high brightness. Selection of imported light, single LED can 11LM, special products, professional design, fully comply with the general production stations on the national standards into (GB50034-92) 100-200 lux illumination (Lux) requirements. 7, LED light and solar energy-saving fluorescent light emitted is also very similar, it can be very good to protect their eyesight. In line with strict rules on plant station on the color index of various raw materials, components and products itself true and accurate colors appear, favorable product quality control, reduce the chance of error. Installation instructions and precautions: Before the installation must check your old fluorescent stent is in what way to drive fluorescent tubes, electronic drive or inductor (coil) drive, if it is electronic-driven approach, it is necessary the original electronic town Connect the power flow apart, and the lamp and electronic ballast cable cut, if the inductance (coil) ballasts, without changes to other lines, the light tubes and starters removed and replaced with LED lights tube can be used normally. ① Remove the traditional fluorescent tube lamp rotation. ② Turn off the power switch, open the holder cover, remove the electronic ballast and starter. ③ AC mains input zero, two FireWire two tap lamp, and make insulation measures (head position wiring electrical insulating tape wrapped); note the need for a working knowledge of electrical safety, such as the user does not have a working knowledge of electrical safety, shall ask a professional electrician. After checking the wiring is correct replace the bracket cover (locking screw fixation). ④ your purchase to the same specification length of LED fluorescent tubes bracket. ⑤ Close the master switch, turn on your replacement fluorescent tube switch, you can light the lamp.