EEFL inverter Liaoning

First, the product technical parameters Product Specifications Input Voltage Input Power Input Current Power Factor ambient temperature the number of lamps delayed 30 220V ± 15% 180W 0.82A 0.99 -10 ℃ ~ 50 ℃ 20 ~ 30 supported and dragged 20 220V ± 15% 130W 0.98 A 0.6 -10 ℃ ~ 50 ℃ 10 ~ 20 supported and dragged 10 220V ± 15% 60W 0.45A 0.6 -10 ℃ ~ 50 ℃ 5 ~ 10 supported and drag 5 220V ± 15% 30W 0.22A 0.6 -10 ℃ ~ 50 ℃ 3 to 5 Note: The above specifications are equipped with electronic inverter ￠ 8mm diameter, length 1.2-1.5 m of conventional EEFL cold cathode fluorescent lamp. Second, wiring methods: Third, pay attention: Mains requirements: AC185 ~ 250V, 50 / 60Hz. Number of requirements: the number of matches for all products and the lamp can not exceed the number of lamps above range. Wiring Requirements: According to the product label wiring diagram, connect the inverter input and output lines, and a cable for the lamp than 5KV high-voltage, electronic inverter output cable lines and tube kinking in When applying together for an anti-power silicon rubber rear of available interfaces knob closed high hat, not electrical tape packet interfaces, otherwise there is a danger of fire ignition even when the plurality of inverters simultaneously output lines as short as possible, not more than 1.5 meters, the output line can not be bundled together, otherwise it will interfere with each other, damaging the inverter. Set Requirements: Lamp card and EEFL cold cathode fluorescent lamp is connected to the electrode to be installed in place, tighten, not loose or bad, otherwise it would have burned lamp card and power lines, or even cause a fire hazard. Do not use non-standard lamps hedging. Installation requirements: common type EEFL electronic inverter is intended for indoor or moisture, moisture places, if the installation should use waterproof EEFL electronic inverter and accompanying outdoor waterproof accessories. Warranty problem: The company is committed, where the purchase of the company's electronic inverter from the date of manufacture from the product specification without departing from the scope of use limit the number of lamps and the ambient temperature under normal use conditions -10 ℃ ~ 50 ℃ and warranty 1 year, otherwise, it is not within the warranty.