Factory direct mobile power transfer film

Thermal transfer spent film Hot Stamping processing Note: stamping, it is a special printing process, it works is very simple, by applying heat and pressure to spend on the film's graphic product transfer to, however, in the specific production practices , to improve product quality, increase productivity, but also need to pay attention to the following points: 1, to keep clean: keep the machine table, guide roller, buttons and other parts clean, not contaminated with oil and other stolen goods; to maintain the Flower Films clean, not contaminated with oil, fingerprints, dust, etc. to keep a clean plastic head, can not have stolen goods, coke block adhesion on the operator's hands should be kept clean, can not sweat, oil or hot to spend membrane products to remain hot was clean, not stained with dirt, oil, etc. 2, stamping temperature: Stamping temperature depending on stamping equipment, stamping Flower Films, Hot Stamping and different, do not blindly pursue stamping temperature (lower is better) It should be based on the effect of stamping After stamping as a benchmark to determine the temperature. 3. Stamping pressure: stamping pressure must be adjusted to the most appropriate or too easy to hurt the plastic head and the hot thing, too small to affect the stamping and effect. After stamping pressure adjusted to the optimum pressure regulator should be locked to prevent changes in mass production. 4, transfer time (speed): transfer time (speed) shall be determined on a Hot Stamping in effect under the circumstances to ensure the stamping faster the higher the efficiency of production, but some products due to some special conditions limit compulsory in only at slow stamping.