Leeport thermosetting silver paste, hot paste thermosetting imitation supplier

Printing method, thermal ink (PLASTISOL) is characterized by a large fine particles can be printed fine patterns. Therefore only suitable film in order to make the ink play out its advantages. It is best to use specifically for thermal ink (PLASTISOL) printing out of the film, on the gradient, pay attention not to lose time copy outlets. 2, mesh choice is also important, the mesh of different colors are sometimes different for different colors of clothes, mesh requirements are also different, in general dark clothes mesh mesh used will be smaller. Recommended mesh: four colors: 250-350 mesh, the network effect: 160-250 mesh, high opacity ink / foam: 80-230 mesh, metallic effect: 100-130 mesh, flash: 30-40 mesh, reflective : 81-110 mesh, three-dimensional effect: 80-100 mesh. 3. For the different components (cotton, synthetic), different colors of fabric, to feel, colors require different or want to achieve special effects, to choose the right ink series, or add different additives. For example: To print four-color reduction effect, should choose four colors series; dark clothes available high opacity inks; optional elastic nylon fabric series; TC cloth material to prevent color bleeding disperse dyes, it is best to use impermeable color white primer, heat-ink printing ink end use dilute slurry of water dilute, than one of the three parts of the left and right side dilute printing ink printing, printing paste to force the end point, so will a lot of firmness. 4, the printing order: light-colored clothing light - dark (continuous printing) - Drying 160 ° C dark clothing, white --120-140 ° C bake to the semi - continuous color printing - bake dry as above. 5, blade hardness: 70 degrees, angle: 40-60 degrees, the frame and deck spacing: 0.2-0.5CM; four-color solid ink and printing is available 70 degrees, high opacity inks to reduce blade hardness 60-65 degrees.