Timely delivery gate hoist Delivery

Gate series: steel gates and iron gate two models. Steel gate with high-quality steel for the substrate, using rubber seal (available for a gate surface sandblasting, spray paint anti-corrosion metal products drawings production according to user requirements). Iron gate: flat iron gate, curved iron gate, high-pressure cast iron gate, shoot the door, tide gate. It may adopt inlaid copper, stainless steel, etc. seal according to the user's needs. Gate Installation Notes: 1, before the gate installation, first check all bolts loose joints is caused due to the transport loading and unloading, if loose should be tightened. 2, only the water check the main frame and the horizontal frame stand on whether there is link dislocation, dislocation if the loose bolts will adjust the water stop in the same plane. 3. Installation of gates should be installed in place with the overall ban gate frame, the shutter split installation, to prevent deformation of the gate frame. 4, before pouring the gate after two whole hoisting find a good front and rear, left and right of the correct position, and then adjust the bolts with steel welding and engineering firm. 5, before the factory gates, in order to make the gate, the gate frame fit tighter, reducing the installation space, two meters above the gate in the upper and lower horizontal frame mounted pressure iron board, increasing the top frame of the stand wedges wire. Note that the top wire gap adjustment after cards on iron and wedges removed to open and close the shutter. 6, in the pouring of concrete, flowing into the gate, the gate frame, wedges, baffle gap mortar should be removed to prevent mortar Solidification hoist