Wing drop test machine maintenance

[Product Overview] may face pack, corner, edge for the free drop test, with digital height indicator and height tracking using decoder, which can give accurate product drop height, and the default drop height error no more than 2%, or 10mm. This machine adopts single-arm double-column structure, with electric reset, electric control and electric lifting devices drop: easy to use; unique Hydraulic Buffer greatly improve the life of the machine, arm stability and security settings can be easily product placement, the angle of the impact surface and the bottom fell flat angle error is less than equal to 5 °. [Design standards] ISO 2248, JIS Z0202-87, GB / T4857.5-92 Technical Parameters Display: Digital height indicator (optional) Drop height: 300 ~ 1300mm Maximum specimen weight: 60kg specimen Maximum size: (L × W × H) 1000 × 700 × 1000mm drop panel area: (L × W) 1700 × 1400mm corbel dimensions: 290 × 240 × 8mm drop error: ± 10mm Drop plane error: <1 ° appearance Size: (L × W × H) 1700 × 1400 × 2015mm Control Box Size: (L × W × H) 350 × 350 × 1100mm Machine Weight: 450kg Power: 1∮, AC380V, 50Hz Transmission: Electric Transmission [Note Notes and maintenance] each test is completed, the drop arm must fall in order to avoid the long arm reset spring tension drop deformation, affect the test results, before each drop, please re-position of the motor can be stopped behind the drop button. The new machine to factory installed, shall be added to the slide rod at a suitably low concentrations of oil, anti-rust oil or non-added oil and high concentrations of corrosive oil with a backlog of species). If the oil at the excessive levels of dust a long time set the machine down to the lower part, wipe the finish before the oil, then re-oiled machine. Belongs to impact mechanical equipment, new uses more than 500 times too, shall give each screw fastening one to avoid failure. Lifting shaft and chain to be regularly lubricating. Gearbox oil change once every six months. Non-work should cut off all power to ensure clean lift shaft. Non-operating personnel shall not operate any of the drop test machine.