Corn machine lathe gadget technology

When machining small parts, assembly and disassembly of parts frequently, it was closed when the machine spindle, labor intensive, and the motor use unreasonable. The use of non-stop chuck, spindle can be continuously operated, convenient loading and unloading of parts, productivity is greatly improved. Non-stop chuck generally smaller size for holding the sleeve-blank. Its structure varied, now choose three kinds as follows: (1) holding the outer part of this non-stop chuck chuck structure. Before installing the self-centering chuck on the spindle and flange removed, using the original lathe bearing ring boss position, with screws fixed to the shell chuck lathe headstock. Inserted into the lathe spindle collet chuck hole hammer. In operation, the collet chuck within the spindle with a hammer sleeve and turn, and housing the threaded ring, the thrust sleeve is fixed against rotation. When the clamp the workpiece, lever handle, thrust collar by Rolling inner sleeve to the spindle end, then tighten the collet chuck. When removing parts in the opposite direction lever handle, collet chuck automatically open. This fixture is simple, easy to operate: When handling parts, no downtime. (2) non-stop clips at the part of the inner bore of this cartridge structure. This cartridge is suitable for installation in C6132 car bed. Before installing remove the chuck, clamp flange 4 is mounted on a spindle: non-stop chuck housing 5 and flange 4 together: taper chuck body 3 is inserted in the spindle taper hole. In operation, the chuck body 3, pin 2, the mandrel 7 are together with the spindle rotation. When the workpiece is clamped, pulled the handle 6, through the plane bearing, pin the core rod 7 left, collet chuck open clamp the workpiece 1. Remove the workpiece, move the handle in the opposite direction, the right use of the stem, spring Chuck contraction, relaxation workpiece. (3) Special non-stop chuck designed to stop turning the hex head screws can be used in general machine chuck lathe. Piece hex head into the hexagonal hole in the recessed fixture, with the right against the top. Shaking tailstock hand wheel, seat Jane tail protruding top and push the workpiece moves to the left sleeve 3, when combined with sub-sets of 3 in mounted in the spindle taper in the clutch 2 is connected, the workpiece that is rotated. Block after the end of Jane retracted in spring 1 is under tension, binders separate workpieces stops. Related Searches: Two grain corn machine | punch hit corn machine http://www.dgxiongjie.com/dgweb-33212.html Tel 13412801161 Liu Sheng