Wash Solution anilox cleaning agent

Applicable Performance: Wash Solution, also known as anilox cleaning agents, anilox roll from film, mainly used for cleaning the dry compound Cots are dryness of adhesive residue, it can also be used to clean the printing plate roller cleaning the effect is very good, easy to use, peel fast, is currently the more widely used products. Anilox roller in a flexographic printing press, offset and even machine coater, corrugated boxes printing presses, coating machines and other equipment is a key component in the printing, coating, the coating process water-based inks, coatings, paints often anilox network points will gradually form a cured layer clogging the network points, thus affecting the printing, coating, coating effects. Clogging the network points cured layer is generally difficult to clean from the network points. Anilox cleaning agent, which is characterized by ease of use, the effect is significant, it does not require any auxiliary set, in a relatively short period of time can be the mesh points in inks, varnishes, coatings and other cured layer removed, restored to a clean roller, maintaining its original transfer ink, coating results. Usage: First, before using this cleaning agent, ask the user to bring rubber gloves, glasses and anti-labor. Second, pay attention: the anilox roller surface should be cleaned is dry, if the anilox roller surface with moisture, it will affect the cleaning effect. Always use a dry cloth to wipe dry the water on the anilox roll. Third, open detergent bottles protective cover of the cleaner with a brush evenly on the surface of the anilox roll cleaning agents must completely cover the surface of the anilox roll, the coating thickness of approximately 0.5 ~ 1mm appropriate. Then cleaners cap tightened, so as not to affect the future. Fourth, wait 15 minutes or so, then you can find color ink cleaning agent has been contracted. Then anilox special wire brush, using reciprocal rotation, and gradually the entire surface of the anilox roll evenly scrub. The aim is to allow the cleaning agent residue cleaning the bottom of the network points out. You can then use a small amount of water, relying on a dedicated anilox wire brush to scrub off the anilox surface gradually cleaning agents and residual cured. Fifth, and finally with water to clean the surface of the anilox roll and the anilox roller surface moisture to dry, then you can see to be cleaned anilox showing cermet qualities, the cleaning process is complete. Six, if we find there is still a small amount of residual anilox roller surface adhesives, inks and other traces of the cured first anilox surface moisture is completely dry, then repeat two to four cleaning procedures for leaving adhesive , traces of ink and other cured place to brush a few times. At this point you will be able to get a clean anilox roller.