Cable fittings 500m span cable adss Preformed suspension clamp fittings Qufu Lu Line

Earthquake Hammer Product Details: Composition: galvanized iron hammer, hot galvanized steel, aluminum clamps, stainless steel bolts. Purpose: to eliminate or reduce the cable when running wind generated due to vibration in order to protect cables and fittings. Features: Harrow typical design, the basic principle is the dynamic energy absorption, the frequency range of 6Hz-150Hz, and in this context there are four resonance frequencies, OPGW meet the needs of various types, with very effective damping effect. A classic tuning fork. Second, the high-pressure metal-filled adhesive bonding. Third, the aluminum clamp block with one strand casting molding and punching reinforcement. Fourth, easy to install, connect securely opgw and adss cable suspension clamp installation methods: (1) with a thin tape the cable suspension point and central location make a fitting marks (2) 2-3 center marks root ready inside a mountain of twisted wire pre-beam, the center mark and the sub-beam step (1) is installed in said mark is aligned with the cable. (3) 3-4 ring beam is wound on the cable. (4) repeating steps within the remaining 2.3 skein wound on the cable. (5) without the use of any tools, both ends of the winding is completed all of the beamlets. (6) the center position of the center portion of the rubber sheath with two markers in the skein aligned and embedded in the outer surface of the skein with a thin section will take the two-part fixed. (7) The central location outside the skein of center mark is aligned with the rubber sheath halves to ensure a curve along the outer skein rubber sheath surface. (8) of the outer sheath of the skein wound 2-3 laps on each side to ensure inter-twisted wire and the rubber outer sheath without gaps. (9) Repeat step 7.8, the second extraradical skein installed in a symmetrical position of the first root of the skein. (10) wound remaining outer twisted wire, twisted wire clearance to ensure uniformity, no cross. (11) without the use of any tools, all the outer end of the skein wound in place. (12) the center position of the center alignment of the outer aluminum casing twisted wire markers, so that the casing merger as a whole, covering the outside of the outer wire cutter. (13) U-shaped hanging ring, PH-type extended ring coupling fittings in place, put the bolts and tighten well nuts, washers and other standard parts, plug relax cotter pin. (14) fixed to the tower suspension clamp fastening on fittings. (15) installed. ,