Ellis battery sales

Ellis battery sales service hotline: 010-56279897,13366467520 Online Customer Service QQ: 2295178169 (1) Long service life of high-strength tight assembly technology to improve battery assembly tightness, prevent loss of live material, improve battery life. Low acid proportion of electro-hydraulic, improve charge acceptance, enhanced capacity battery deep discharge cycles. Increase the amount of acid design ensures battery electrolyte depletion will not shorten battery life. So normal float design life GFM series battery up to 15 years (25 ℃) (2) excellent high rate discharge performance of high-strength tight assembly process, the battery internal resistance is extremely small, excellent large current discharge characteristics, higher than the general cell 20 [%] the above. (3) low self-discharge high-purity raw material and special manufacturing process, the self-discharge is small, can be stored at room temperature more than six months without having to make electricity. (4) easy maintenance Special oxygen absorption cyclic design overcomes the battery during the charging process of electrolysis of water loss phenomenon, in the course of almost no change in the moisture content of the electrolyte, the battery in the course completely without water and simple maintenance. (5) The internal battery is equipped with a special safety valve, can effectively isolate external sparkle, will not cause the battery to explode inside. (6) Install simple battery of vertical, lateral, can be stacked installation, small footprint installation, flexible and convenient. No mist (7) clean environment battery on the surrounding environment and supporting the design of non-corrosive, can directly to the battery installed in the equipment room or office without the need for preservatives. Battery charge and discharge characteristics  battery self-discharge effect. To the user from a manufacturing plant, about to be delayed several months. In PA-NASONIC batteries, for example, at 30 ℃ ambient temperature storage of 8 months, half of the remaining battery capacity is only at the factory, so for the purchase of new batteries and UPS support, generally once a long time charging, which is called the initial charging. First the charge current to charge the battery should be 0.1C, the battery after the discharge end can be recharged, is called the normal charge. UPS is currently in widespread use two charging methods: float and pulse charge. The so-called floating charge refers to the rectifier output and the battery in parallel, and also to the load, in fact, at this current rectifiers provide two routes, all the way to the load, and the other way to the battery, in order to supplement its own internal battery loss, floating rechargeyour simple wiring work, to improve the UPS output transient response is good.