Undertake professional network cabling installation Hainan Haikou network cabling installation, reasonable ..

Undertake professional cabling installation, reasonable prices Haikou, Hainan network cabling network installation, professional service attitude. Hainan Liansheng Technology Cabling System details special attention: the cabling system is the most complex is to maintain and safeguard the most important thing is to clearly distinguish the identity and direction of the outlet, from the engineering point of view I did, everyone in the construction process should pay attention to a few details of the following: 1. Front: the front of the line head must use oil-based pen-written labels, logos on the panel must be clear, with a note on the front panel can be turned over by hand or a good amount of size, After printing with advertising stickers again posts good. (Suggestion: a handwritten note on the label panel is in the construction process, the back of the machine-printed label when completed finishing paste). Another good suggestion is: you can write on the top panel cover with an oil pen label, with plastic wrap cover panel of the panel, after the test is completed and then reversed the panel cover lid on OK. 2. MDF Front: patch comes with handwritten labels, if the construction cycle long, then the construction site or moist, is recommended to be marked with handwritten labels, until the completion of the test is completed when the re-play replacement labels , machine-printed labels with front panel selection as advertising stickers, black and white. 3. patch on the back: this is very important, we have seen a lot of hair cabinet diagram, label patch on the back of the jumpers did not do, or just use oil pen handwriting, we recommend you use number of tubes (there are two kinds: a species are machine-printed white casing, numbers can own play; the other is the number of letters and figures tube, I usually choose the letters and numbers of yellow numbers pipe), thus ensuring that the label is still clearly visible after 10 years . ----- Set number tube is not time-consuming, the cabinet before the wire line usually good points, strapped with a tie, this time is set when the number of tubes. The switch to the patch panel jumpers: Conditional use labeling machine for direct printing, no conditions of use another method, but also very beautiful and clear. (The quantity of a good size, with a good paper to print directly Well, then cut tied with transparent tape a few times, I usually use yellow A4 paper, printed with a laser. Jumper 2 should be marked.) 5 The cabinet wiring table: Wiring table to do with A4 paper, laser printing out a plastic first, and then the corner of the hole marked with a tie put on, placed in the cabinet. So easy future maintenance. 6. Fiber Jumper: identification would not have said, if you transferred to another rack cabinet from below, it is recommended to use bellows, corrugated pipes secured thereto tie rack. 7. If able to do so, try to do the load-bearing frame angle, do not dig holes in the floor leads directly out of this thing in the load-bearing frame construction and maintenance is very convenient. What other tying jumper corners, off the assembly line, the ground floor under treatment and so on, do not say. Above said these, is the need to pay attention to several details of integrated wiring systems engineering, it is not time-consuming, we hope to play to their talents in the project, from the actual needs of customers, combined with on-site to solve the problem, the project do a good job. [Hainan Liansheng Science and Technology Development Co., Ltd.] Contact: 18889798499 Miss Wen