Belt repair glue SK313

Belt repair glue SK313 cold curing adhesive, a patch for the launch of a belt of high-performance, two-component plastic belt, belt repair products for cold vulcanization seamless bonding, adhesive bonding drum kits with special effects . Belt repair glue SK313 cold curing adhesive flame temperature up to 140 ℃, its adhesive strength and heat curing adhesive curing machine by means of the same level, is the belt repair, pulley lagging choice! Belt repair glue SK313 cold curing adhesive to operate 1. tungsten steel grinding plate or wire wheel breakage of the belt will be fully polished (not shiny), then cleared away the dust with a brush (do not use water or chemical solvents) . The residue worn, weaving mill and then light (be careful not to damage the fabric layer), cleared away the dust (do not use water or chemical solvents). 2. Remove the metal surface oil, then polished with sand or sand blasting wheel with RAMIMTECH cleaning agent. If you need RAMIMTECH coated metal primer, and let it completely dry. SK313 belt repair glue and curing agent, 100: 4 ratio and stir evenly mixed. (That is, 1 kilos SK313 with 40 g curing agent). Yin US special Tips: Must be used within one hour after mixing, or hardening of failure. 3. The combination of coated with a thin uniform layer twice, BL adhesive layer surface of the first layer without coating. The first layer must be completely dry (25-30 minutes), and to reach the degree of finger no longer attached to the back. The second layer of dry to slightly sticky when there are (with a finger back again), to the final adhesive surface. (If the second layer is too dry then apply a layer). 4. The combination of the two faces stick together, to avoid air bubbles, tightly fitting and compaction. That repair that is used, so that downtime to a minimum. Yin US special Tips: Yin US special RAMIMTECH recommended metal primer pre-treatment of metal surfaces to improve the rubber and metal bonding and reliability of plastic drum kits.