Signs welder telephone number

II. Technical parameters: 1 Power: Method One; AC AC220V 50-60Hz Method two; car battery DC12V Method three; built-in battery 2 Input Power: ≥500W 3 output power: Cured 4 Weight: about 15Kg 5 welding materials: carbon steel, alloy steel, stainless steel three works: a large current pulse SD-3150 host of imported power electronic and electrical circuit, can instantly output energy, highly concentrated, the workpiece and signage studs, produce enough energy to heat rapidly and connection points welded together, enabling the signs hanging fixed. IV use: Method 1: The AC220V 1 connection welding, the ground wire, torch cable, control cable to the corresponding jacks on the front panel welder. 2 Connect AC220V, AC220V plug the rear panel, insert external AC220V outlet. Close the front panel power switch, then welding machine is in standby mode. 3 will be caught in the clamp are welders, holding office should ensure no oil or corrosion layer. If significant corrosion layer, move away, or angle grinder at the metallic luster polished before connecting. 4 The label specified location on the workpiece, the welding torch nail inserted into the groove at the plate is welded studs through pressure on the workpiece. Gently press a switch on the torch and immediately release the end of welding. (Note: You can not time the gun pressed against the workpiece) using Mode 2: 1 using the battery-powered car DC12V AC220V AC plug on the rear panel, insert AC220V socket on the rear panel, according to the polarity and welding connections. (Note: can not avoid wrong polarity) 2 All Model II in an identical pattern. 3 If no output may be at the front of the reset switch (Note: You can not time the gun pressed against the workpiece) use three 1 charge left twisting the rear panel switch open to AC220V, the right kink switch open to the charge, Open the front panel power switch, power indicator and charging indicator light up, and charging starts, the charging time is about 8-10 hours 2 built battery welding, the rear panel left open to kink switch DC12V, right-Toggle Switch welding, Open the front panel power switch, you can weld Note: not long gun pressed against the workpiece 3 car DC12V battery soldering machine with red and black terminals on the rear panel (red positive black negative) connect to the car battery positive and negative (Do polar can not be reversed) and the built-in battery welding other modes same note: not long gun pressed against the workpiece 4 AC220V welding mode and use the same five a packing list: 1 power supply (host) 1 2 torch output cable (with fast connector) 1 3 ground output cable (with quick connector, clamp) 1 4 1 Warranty card 5 specification 6 Troubleshooting Common Cause No. Causes Solutions 1 Boot no display No power input Check the power input or 5A Insurance 2 nips nips ignition oil or degreasing rust rust 3 welding is not strong inhomogeneous material composition and the other for position welding 4 pressure switch machine gun no current output is bad, adjust the position of the loop is not formed 5 12V positive and negative power supply can not be reversed or 5A blown fuse replacement inverter or 5A Insurance