Wire feeder, Renqiu Laoding Wei-off diagram, wire feeder board

Species wire feeder, in the housing has a gas supply pipe, wire feeder outlet for the European socket head, welding cable and the housing, gas supply pipe, and the wire is connected to the outlet; wherein the wire panel mounted in the housing; wire disk support shaft damped locking plastic parts; the housing is also a gas supply pipe support, the casing side door with a wire, the wire feeder is equipped with a hinge between the door and the casing; the housing further provided with a rod-shaped handle, one end of which is provided in the front end of the top of the housing, and the other end provided at the rear end of the top of the housing; in addition, the rear cable housing is connected with an external device may be fixed , may also be a socket type. The utility model will torch switch wire feeder, welding cables, gas source tube into one output, which can be accessed European torch, easy to operate; secondly, the spools are placed within the housing, and the installation of locking device, so send silk uniform, not loose wire and wire to prevent contamination, is conducive to maintenance of equipment; installation of a handle after overcoming the previous wire feeder center of gravity of the defect, easy to move; and there are two cable connections for users Choose. Spot-welding robot is not very high. Just because the spot-position control, as the welding tongs to move trajectory between points is not critical, and this is the reason the robot was first used only for spot welding. Spot welding robots not only have sufficient capacity, and between points when the shift speed is fast, action should be smooth, positioning must be accurate in order to reduce the shift time and improve work efficiency. Spot welding robot needs much load capacity, depending on the form used for welding tongs. With separate transformer for welding tongs, the robot 30 ~ 45kg load is sufficient. However, this welding clamp hand due to the secondary cable length, power loss, is not conducive to the robot welding clamp the workpiece inserted into the internal welding; the other hand, cable and keep swinging with the robot motion, damage to the cable faster . Therefore, it is gradually increased with integrated welding tongs. This together with the transformer quality welding clamp around 70kg. Considering the robot to have sufficient capacity, able to large acceleration to the spatial position of the welding clamp welding, generally use heavy-duty robot 100 ~ 150kg load. In order to meet the continuous spot-welding tongs short distance fast shifting requirements. The new heavy-duty robot increases can be completed within 0.3s 50mm displacement functions. This performance of the motor, the computer's operation speed and algorithms are put forward higher requirements.