Treasure electrodes 220,021

US sea treasure MAX200 plasma cutting machine. The use of US sea treasure such as plasma cutting machine wearing parts, consumable parts of the torch needs to periodically check for signs of wear, heavy wear will affect the cutting effect, the need to replace sea treasure plasma consumables. Removing the sea treasure such as plasma cutting machine consumable parts: 1. Unscrew the cover. First, the torch moves to the edge of the sea treasure such as plasma cutting machine, cutting torch to its highest position, avoid the replacement parts will not fall into the water wearing parts. 2. Check whether the shield for signs of wear, the shield should have no slag metal kept clean. The edge of the vent shield metal slag should not be blocked. Do not have a gap in the center of the hole to prevent the plasma arc offset. 3. Use a wrench to remove the shield, check the internal pores. Do not be slag blowhole. If the shield is not damaged, screwed back cover is fixed with a wrench. If it is damaged, it should replace the shield. 4. Check the two O-rings on the torch should be lubricated and not damaged. Should be coated with a thin layer of lubricant to the O-ring, if the O-ring is damaged, replace the O-ring. 5. Use a wrench to remove the US sea treasure such as plasma cutting nozzle. Check plasma cutting nozzle for wear or damage. Inside the nozzle should be clean, no electrodes deposits can steel wool to clean inside the nozzle, the nozzle orifice should not wear. 6. Use the wrench to remove the Treasure plasma electrode. If the center electrode 2 mm deep pits, replace the electrode. If the electrode is not damaged, check the electrode was O-rings, lubricate O-rings or replacement. 7. Remove Haibao accessories vortex ring from the sea treasure plasma electrode, hole vortex ring should not be blocked. If vortex ring well, check the above O-rings, lubricated or replaced. 8. Check torch body, clean the inside to see if there is damage. Check that the pipes are loose or damaged. Loose or damaged pipes can cause: electrode life is shortened, two flow switch interlock is a system shutdown, torch body 3 will be buzzing sound... 9. Install the US Treasure plasma cutting machine consumable electrode, swirl ring, cutting nozzle, fixed cover shields to tighten, but not too tight, tighten moderately.