Casting roll-headed automatic welding plane

1. adaptation of the workpiece and welding the outer diameter of the workpiece: Φ150-Φ500mm 2. workpiece length: stud welding 2X2000mm, single head welding 5000mm 3. Maximum workpiece weight: 5000kg 4. Welding: submerged arc welding according to the welding process Requirements can choose spiral welding, stepping surfacing, surfacing swing different welding processes. Can be easily preset by the touch interface welding parameters, change parameters and state transitions as well as procedures for storing and recalling the welding process workpiece 1. The workpiece mounted to the positioning tooling, lifting the left and right to adjust the torch in manual mode, make gun the alignment from solder joints. 2. On the touch screen to select the welding process and the way and set the process of welding parameters, adjust the appropriate welding current and voltage. 3. Switch to automatic mode, the workpiece clamping, press the start button, the program will automatically arc welding, start the workpiece, welding swing open, according to the set speed, bead width, welding layers and other parameters automatically. 4. After welding is completed, the program automatically stop all action. Welding, flux complete automated screening and recycling. 5. The removal of artifacts, waiting for the next cycle, if the same welding process, adjusting the alignment of the weld torch, press Start again to repeat the same welding.