Supply sows bed manufacturers

Sows bed and Installation instructions: 1, screw the bed capacity of six legs and frame (frame contains around four 1.8 m of flower beams and 2.1 meters at both ends of two vertical beams) fixed, but do not overtighten, so that when the adjustment; 2, the interval between the vertical beams bed followed: 50cm, 60cm, 70cm, 70cm, 60cm, 50cm, with screws and tighten the flower beam, be careful not to overtighten, convenient adjustment; 3, floor laying followed by sequence (Span): 50cm, 60cm, 70cm, 70cm, 60cm, 50cm; 4, the bed frame production equipment: a short iron bar between a, equipment 2.1 m fence, two 45cm front door, door and fence coupling; b, the main frame, the bottom of the beam is coupled with screws with flowers, coupled with an iron bar and other parts of the shelves; c, some other similar device. Two 1.4 m fence device in the middle of the bed capacity, connected to the main frame with an iron bar. Main frame side with the "U" shaped clip with a 65cm iron pipe connection. 5, incubators put the middle, with 2.1 m iron pipe fixed. Sow manger fixed on the front door with screws. Hand kneading trough piglets up the screws pierce the ground floor, rotating and fixed. ? 6, and check, you can put all the screws tightened installed.