Xuzhou submersible drilling rig

 Submersible drilling rig before entering, must level the ground, ready skids tools. After entering rig, rig skids must elevate the tire off the ground, and adjust the rack into a horizontal position: After power on, can start the motor, lifting mast, after lifting the mast, the mast at the bottom of the screw rotation out and supported to the support; then lever frame legs, stretch strap attaching well and adjust screw to adjust the lever, guy wire tension level. DTH drill rig roll rope drawn from the roll by the impact beam guide pulley and the tension pulley and then into the hole at the top of the mast pulley and sagging, which took over the rope end joints connected to the drill string. Roll rope through the top of the mast mud mud sheave and sag, so the tip is connected to the mud of the barrel. Submersible drilling rig auxiliary drum and bottom of the mast with the use of three fixed pulley. Submersible drilling rig drilling the workplace should be kept clean. When submersible drilling rig in the installation and removal, to ensure correct and intact. When the rig mast lift, the operator should be standing safe location. When starting the motor, it should be open to all of the friction clutch rig. When the rig is strictly forbidden to remove the protective cover. Before work begins, you should check the reliability of the braking device, as well as performance of the friction clutch and starter. Rig daily because blockout and holes may cause sticking and should therefore periodically adopt impactor strong blow, regular cleaning the hole bottom. In the course of the coupling lever, rock debris and impurities fall into the impactor, it must cover the drill screw loose ends, make sure the drill stick of rock debris and dust. Reasonable lubrication impactor can never be ignored, otherwise the impact will accelerate the wear and tear or damage. For more information, please visit submersible drilling rig www.yantuojx.com