T06 type of small hand press riveting press

T06 type of small hand press riveting press 1. Instrument Description T06 type manual press is a press dedicated specifically for sample preparation laboratory and design, machine design compact, flexible and convenient, very suitable for the thickness of 0.02-0.15 battery anode, separator paper, stainless steel sheet , nickel plate and other materials to carry out the blanking. With different size of the mold can be punched in the sheet material, blanking, stretching, forming and other processes. It can also be used for assembling, riveting and some other small parts of the work, and versatile. 2. -Instrument components: handle, slide the upper mold core, lower die, lower die fixed block, press table, adjustment screw. 3. Instructions 1. Die die-holder fixed to the press will be equipped with work surface (via fixed mold block and screws), the mandrel into the press Shank hole. 2. Adjust the height of the press closed, the upper mandrel smoothly into the lower die 0.5-1mm (pay attention to adjust the gap between the core and with the concave mold); 4. regulate the mold core and concave mold then with the gap, according to the needs of sectioned material, incorporates matching binder mechanism that is mounted in the mandrel; 4. Lift the mold core, platinum will be punching sheet material on a mandrel and a concave between the mold, moving the handle can be punched. Four. Notes: 1. The press must be released after one rotation lock nut inside the cover closed when adjusting the height or 1/2 turn, then rotating the upper part of the press after adjustment screw to the desired height closed, be sure to lock tight nuts, remember! ! Please use the special wrench operation. 2. Adjust the gap with the abrasive mold core and between the lower die, to make the core unhindered into the concave mold, the mold core into the lower die punching distance of 0.5-1mm effect The best. The core into the lower die distance can be achieved by adjusting the height of the press closed. Must not be forced to handle when pulled because the core and concave mold with a small gap, son ah did not adjust the gap, damage on one side of the core and the lower die cutting edge; 3. around punching of 0.02mm When the separator paper, and its thin and soft, 5. When the need to replace the mold core and the lower die, the need to loosen the screw connection concave mold and die-holder, the removal of the lower die, load needs concave mold, tighten the connector screws. On the same core replacement procedure, loosen the screws on the core system Shank air outside, remove the core, put on the required core, tighten the mounting screw. After each complete replacement of the mold core and the lower die, you must first check with the gap on the mandrel and the lower die, as a deviation with the gap, the need to re-adjust with the gap on the mandrel and the concave mold. 6. Press the handle angle can be adjusted, but in order to achieve maximum blanking force, pulled endure more effort, it is recommended to handle and the ground was adjusted to about 45 °. With different size of the mold can be punched in the sheet material, blanking, stretching, forming and other processes. T06 type of small hand press to manually punch riveting press T06 precision manual presses, manual presses Main Specifications unit Model T06 nominal maximum stroke finale closed height minimum height Throat depth column closed with the finale from the handle hole diameter work table size shape Dimensions (L × W × H) Weight kn mm mm mm mm mm mm mm mm kg 6 (600 公斤) 40 220 90 120 119 Φ12 180 × 170 190 × 230 × 450 38.5