Plumbing pipe drawing links Cangzhou & Tengda Machinery & welcome you to order

Tenda production and sales of model 25-426 model drawing three-way machine is used for carbon steel, stainless steel pipe made of Tee of special hydraulic drawing machine, inner tube with liquid stretch forming, forming the largest size 426. Drawing three-way machine adopts PLC control, while pressing synchronization products with high performance, convenient operation, equipment and ultrahigh pressure relief valve and turbocharger, can meet a variety Tee molding. Drawing three-way machine ready before the start: 1, before the start of commissioning, start steel drawing machine oil pump, observe and adjust the lubrication points, lubrication points should not have starvation phenomenon, the system should not have leakage oil return pipe must be smooth. 2, start the fan, observe the duct is smooth, air flow is appropriate. 3, adjust the cooling water, observed through the roll and wire drawing dies box cooling water is smooth. 4, test run if steel drawing machine is not running smoothly and high temperature phenomena, must be checked before starting again after troubleshooting. 5, before the operation, to check the steel drawing machine transmission parts is normal, the electrical system without fault, fixtures and protection devices is good. 6, before the turn, you should check drawing module specifications meet the provisions, put the right amount of lubricant in wire drawing dies box and add at any time on the job under the circumstances. Before the steel head by drawing a small amount of mold should be wiped lubricant.