Heavy roll lathe Caution

Matters CNC roll lathe machine use should be noted that (1) CNC roll lathe machine operators, maintenance personnel must be mastered professional or technically trained staff expertise appropriate machine, and the machine must be operated according to safety rules and regulations for safe operation ; (2) non-professionals do not open the cabinet door, open the machine must be sure that you have turned off the main power switch on the front cabinet door. Only qualified service personnel are allowed to open the electric door, energized maintenance; (3) In addition to some of the parameters available to the user and can be altered, other system parameters, spindle parameters, servo parameters, unauthorized users can not modify, or will the operation bring equipment, parts, and other personal injury; (4) After modifying parameters, for the first time, machine tools without the tool and the workpiece loading test run with the machine lock, single block, etc., confirm Machine normal after using the machine; (5) machine tool manufacturer PLC program is required by machine design without modification. Incorrect modifications to the operation of the machine may cause damage to the machine, or cause injury to the operator; (6) suggested that the machine up to 24 hours of continuous operation, if continuous running time is too long will affect the life of the electrical system and other mechanical devices, which will affect the machine accuracy; (7) CNC roll lathe machine All connectors, joints, do not allow live Stubbs, insert operation, otherwise it will cause serious consequences. 2. CNC system when not in use for long-term maintenance of CNC system to improve the utilization and reduce the failure CNC system, CNC machine tools should be at full capacity use, rather than long-term idle, for some reason, resulting in long idle when the CNC, in order to CNC system to avoid damage, note the following points: (1) to the NC system power often, especially in the environmental humidity of the rainy season and even more so in the case of the machine does not move in lock (the servo motor does not turn time), so that the NC system dry run. Use of electrical heating element itself to disperse moisture CNC system to ensure stable and reliable performance of electronic devices, proven in the air humidity areas, electricity is often an effective measure to reduce the failure rate. (2) The vehicle rolled bed CNC roll feed machine with DC servo drives and DC spindle servo driven brush should be removed from the DC motor in order to avoid corrosion due to chemical action, so that the commutator surface corrosion, resulting in commutation performance change bad, and even the entire motor damage.