Specializing in the production of T-slot plate to find good products in Bo Feng Gang, quality assurance

Contacts: Feng Gang Tel: 0317-8319626 Mobile: 15133799602 Working QQ: 545837729 T-slot platform, also known as the T-slot plate welding Rivet T-slot plate, the assembly T-slot plate, T-slot base plate, cast iron T assembly and commissioning, the surface with T-slots can be fixed power machinery equipment, requires a larger assembly platform, can be assembled using the T-slot plate main technical parameters-slot plate for power machinery equipment:. 1, T-slot Tablet should be treated by the stability and demagnetization. 2, T-slot plate work surface should not have rust, the appearance of defects scratches, bumps and other effects used. 3, T-slot plate work surface should not have sand holes, pores, cracks, slag and shrinkage and other casting defects. Each casting surface should be completely clear sand and smooth surface, paint firm, each duty shall be rounded blunt edge. 4, on opposite sides of the T-slot plate, and set the proper installation position of the handle or lifting, threaded holes or cylindrical bore. Set lifting position should be considered to minimize the strain caused by lifting caused. 5, T-slot plate face hardness should be T-slot plate Cautions between HB170-220 or 187-255: flat at the first use installation and commissioning. Then, wipe clean the face plate, used in the case confirmed that no problem using the process, to avoid the workpiece and the face plate has a radical impact, prevent damage face plate; workpiece weight but can not over flat rated load, which will cause lower quality of work, there may be damage to the flat structure, or even cause flat deformation, so that the damage can not be used. . T-slot plate material: high-strength cast iron HT200-300 face hardness HB170-240, after two manual processing (annealing 600 degrees -700 degrees artificial and natural aged 2--3 years) use of the product accuracy and stability, resistance Good grinding performance specifications: 100 * 100-3000 * 6000, (larger than this size can be assembled using the assembly platform or by the drawings) plates according to the national standard verification procedures, namely, 0,1,2,3 four. levels. T-slot plate should be made of high quality fine granule gray cast iron or alloy cast iron. . On opposite sides of the plate, set the proper installation position of the handle or lifting, threaded holes or cylindrical hole provided lifting position should be considered to minimize the distortion caused due to the lifting of this document stems from:. Http: //rtjxwx.blog .163.com /