The target type flowmeter manufacturer of liquid gas meter

Flowmeter, it is both orifice, vortex flowmeters and other characteristics no moving parts, but also has high sensitivity, accuracy and volumetric flowmeter comparable, wide range. ● For diameter range is wide: Φ10 ~ Φ2000 to more; ● wide temperature range: -196 ° C ~ 500 ° C; ● suitable for high / low pressure conditions: 0 ~ 42MPa; ● for a variety of media: gas, liquid (including high viscosity liquids, slurries), steam; ● suitable for low flow medium, its lowest measurable flow rate of 0.08m / s. The target type flowmeter technical parameters Product Name: Target Flowmeter Diameter: DN15 ~ DN3000mm Nominal pressure: 0.6 ~ 42MPa conditions Temperature: -180 ~ + 500 ℃ Accuracy: ± 0.2 ~ ± 1.5% FS turndown ratio: 1:10 housing body: carbon steel; stainless steel (or offer by user request) (fluorine) Power supply: Built-in 3.6VDC lithium battery (changed every two years); external supply 24VDC (optional) Output signal: 4 ~ 20mA two-wire system; pulse 0 ~ 1000HZ; RS232 / RS485 (or by user request consultations provided) Protection class: IP65 IP67 Explosion-proof mark: intrinsically safe ExiallCT4; flameproof ExdllCT4 Standard: Enterprise standard Q / BET05-06 first table shows: the cumulative flow; instantaneous flow ; conditions temperature; pressure conditions (temperature and pressure compensation type only); rod percent of full scale; fault detection Connection: double flange, plug-in, clip-target type flowmeter features 1, the entire instrument configuration Rugged with no moving parts, easy plug-in structure, demolition; 2, can choose a variety of corrosion and high temperature resistant materials (such as Hastelloy, titanium, etc.); 3, no dead ends, fully sealed machine to do (welding form) , no leakage point, can be resistant to 42MPa high-pressure; 4, the instrument features self-test procedures, failure phenomenon glance; 5, the sensor is not in contact with the measured medium, there is no wear and tear parts, the use of safe and reliable; 6, may be employed dry calibration method, which uses weights hanging weight method. One-button operation can complete calibration; 7, with a variety of installation methods to choose from, such as choosing the online plug-in, low installation costs; 8, with integrated temperature and pressure compensation, direct the output quality or standard side; 9, with optional small signal removal, non-linear correction, filter time option; 10, can accurately measure a variety of normal temperature, high temperature 500 degrees, low temperature -200 degrees condition of gas and liquid flow rate; 11, measurement accuracy, precision can reach 0.2%; 12 good repeatability, generally from 0.05% to 0.08%, rapid; 13, pressure loss, only the standard orifice about 1/2 △ P; 14, jamming, anti-impurity capacity particularly strong; 15, according to the actual need to be replaced Baffles (target plate) and change the range; 16, low-power battery-site display, can be read online direct indication, the display can be read simultaneously instantaneous and cumulative flow rate and percentage bar graphs; 17, easy to install , easy to maintain; 18, multiple output format, various parameters can be remote; 19, anti-vibration and strong, within a certain range can be measured pulsatile flow.