Asahi electric kettle dispenser automatic dispenser XT-441

Dispensing equipment electric water heater housing program book (heating blocks, plastic shell, plastic handle generic) First, the design requirements Second, the design process planning Third, the program design Four, five technical parameters of equipment, dispensing valve of one, the design requirement 1.1, Products Shell Size: heaters heating base and plastic shell cover different sizes 1.2, dispensing position: base and plastic shell surface of the base circle of a circular groove dispensing; 1.3, the process requires: a round tank wall can not have plastic; glue tank round uniform continuous, continuous plastic; after lamination can not excess glue, can not have bubbles. Second, the design process planning fixture plate material, the material in place boot positioning Z-axis dispensing, finished dispensing, the machine back to the origin of products under the product feed material; Z axis dispensing, finished dispensing machine homing cycle three, Design 3.1, the whole design: 3.1.1. Dimensions (Unit: mm): L580x W586.5x H592 3.1.2, the whole diagram is as follows: 3.2, a major component of the device: A, B automatic dispenser housing product jig station (available with vacuum suction or a card slot fixed product) C, dispensing valve (plastic precise control, can also be used syringes out of plastic) D, Controller 3.3, an integral part of each presentation: 3.3. 1, the automatic dispenser Drive: Stepping + belt + precision linear guide Operating Range: xyz: 400 * 400 * 100mm 3.3, an integral part of each presentation: 3.3.2, product positioning table 3.3, each component part Description: 3.3.3, three-dimensional adjustable dispensing head (which can add to the stud, in order to increase the efficiency of dispensing) 3.3, an integral part of each presentation: 3.3.4, dispensing controller (precise control and regulation of the glue pressure, control plastic precise) control mode: electronic, pneumatic dispensing function mode: quantitative mode, manual mode IV equipment important technical parameters 1, the plastic precision: ± 0.05g 2, machine speed: 500mm / s Four, equipment technical parameters 1, detailed dimensions diagram: five, dispensing valve Description spit Frequency 800 (beats / min) Valve gum off quickly, leak-free epoxy glue B, working pressure: 0.4-0.7MPa