Pulse heat welding

According to plastic parts welding machine requirements with reasonable electronic components corresponding to accommodate continuous uninterrupted welding work. Respectively, relays, solenoid valves, cylinders, ammeter, temperature control, heating pipes, filter cup, pressure regulators, cold mold, electric heating fast, operation panel, thermocouple. 1, solid state relays: Set heating mold heating, curing time 2, the operation panel: the power box panel has a display of the heating module temperature control, there is a power control indicator, the machine head welding machine there is an emergency stop button, 3,2 only green buttons, a red emergency stop button, a welding time setter. 4, filter bowl: pneumatic mechanism for each input stream will be able to extend a water filtration pneumatic original working life. 5, the regulator: on each guide cylinder by the intake, the two regulator. Ali regulator to control air flow through, so as to achieve a buffer action to adjust the rails, making the whole piece of equipment and operating procedures gentle movement. 6, thermocouple: mounted on the hot mold, through its hot mold temperature sensor, sends a signal to the thermostat, then controlled by a thermostat to heat mode switching power supply off, to achieve the desired setting welding temperature. 7, chills: the role of the plastic pieces play positioning, respectively, by the mold clamping module, the lower mold clamping module. 8, copper electric melting module (internal buy heating tubes), plastic parts to be welded to the surface to melt, making good contact surface combined into one.