SA160 Fusheng air compressor oil separator filter 91111-002

Common causes Fusheng advanced coolant temperature is too high: 1: too much dirt or oil cooler hose clogged, oil cooler temperature control valve does not operate, less cooling efficiency; 2: compressor oil aging failure; 3 : oil temperature sensor failure, if you use the PLC control, do not rule out a problem piece of circuit boards; 4: moving parts with the bad; 5: ambient temperature is too high lead to compressor oil temperature high; 6: discharge pressure up to less than a set value; Cause selection error (optional smaller) intake air filter / oil separator clogging intake throttle valve does not operate or malfunctions (in the closed section of the intake valve) within the screw serious leak; 7: Back poor passage. Oil filter is clogged! Insufficient fuel supply; 8: compressor speed is not enough, the V-belt is too loose, will lead to volume decline; 9: poor quality compressor oil, viscosity grow too fast or oil contamination; First check the fuel oil temperature is too high enough enough? Then check the cooler, and then in the spring is the temperature control valve is broken and, finally, no oil filter blocked. 9, to replace the on-site recording time compressor oil and other components, inspection records, and assign responsibilities people. 10, found a large air compressor oil evaporation loss, you should first check whether the oil separator perforation. 11, the screw compressor oil is special oil, there must be someone managed to prevent contaminated accidents everyday. Fusheng advanced coolant Caution: 1, different grades, grade compressor oil Do not mix. 2, you must replace the old oil exhausted. Prohibited the use of additional or filtration and reuse approach. Because although the surface color compressor oil unchanged, but the additive consumption may have exceeded the limit. 3. If the sludge is not much, after loading new oil 1/2, running 15-60 minutes put the net, refilled with new oil running. If the sludge coke too, can open the cylinder with manual removal of sludge and coke, then cleaned with special cleaning agents, but after cleaning, you must use the dry air dry, then add clean oil cleaning 100-200 hours After cleaning the oil put the net, finally adding new oil and running. Otherwise it may not only undermine the performance of oil additives, and could cause accidents. 4, oil changes should also replace the oil bypass filters, oil filters, oil and gas separation fine filter, coarse filter filter element, etc., check collection filter, air filter, check valve, temperature alarm, and so is intact . 6, the recommended oil change is not a fixed value, due to the equipment, environmental impact, mechanical impurities can accelerate aging of the oil. To prevent coke, coking course (300 hours each) still pay attention to the observation color compressor oil viscosity, oil, etc., but can not rely on color to judge the quality of oil. 7, high oil temperature must find the reasons, can not get rid of the protective device in order to maintain production.