Magnetic pump

High-temperature magnetic drive pump magnetic drive pump (temperature ≤250 ℃) (referred to as magnetic pump) is applied to the working principle of permanent magnet coupling gear pump new products include stainless steel. Reasonable design, advanced technology, with fully sealed, no leaks, corrosion-resistant features, its performance has reached the advanced level of similar products. Magnetic pump to replace the static seal dynamic seal, the pump flow components in a completely sealed, completely solved the other pump mechanical seal can not avoid the run, run, drop the ills. Magnetic pump corrosion resistance, high strength engineering plastics, corundum ceramics, stainless steel and other materials for manufacturing, so it has good corrosion resistance, and can be transported from medium pollution. Use: zero leakage magnetic pump, compact structure, beautiful appearance, small size, low noise, reliable, easy to use vertical. It can be widely used in chemical, pharmaceutical, petroleum, electroplating, food, photofinishing, research institutions, defense industry and other units pumping acid, lye, oils, rare and precious fluid, venom, volatile liquid, and circulating water equipment, filtration machine supporting. Especially susceptible to leakage, flammable, explosive liquid was pumping, this pump is more ideal choice. Magnetic drive pump installation and use of a magnetic pump should be installed horizontally, not upright, vertical mounting for the special requirements of the occasion, the motor must be upward. 2, before starting the suction pipe valve can be opened, if suction liquid level below the shaft center line, pipeline to be equipped with a foot valve. 3, use should be checked before the pump, motor fan rotation should be flexible, not stuck no abnormal sound, each fastener to be tightened. 4, check the motor rotation direction is consistent with the magnetic pump turning mark. Magnetic drive pump Caution 1, due to the cooling and lubrication of magnetic pump bearing is being conveyed by the media, so the absolute prohibition empty dynamic change, while avoiding the middle of a power outage before starting work caused no load operation. 2, is transported medium, if they contain solid particles, the pump inlet to add filter: containing ferromagnetic particles such as, the need to add a magnetic filter. 3, pump in use, the ambient temperature should be less than 40 ℃, motor temperature rise should not exceed 75 ℃. 4, the medium and its temperature should be delivered in a pump timber within the allowable range. Metal pump temperature 100 ° -300 °, a particle size of not more than 30 × 10- 6m2 / free hard particles and liquid s of fibers. Sales Hotline: 0317-8292122,8189553, Fax: 0317-8188192