Hebei test pump Professional production of 3D-SY400MPa ultrahigh pressure test pump manufacturers

3DY series test pump installation and use 1. Installation: (1) Install handrails. (2) Install the starter motor and power lines. (3) Install the non-return relief valve. Mounting position shown in Figure 5, the member from trans-cis-way nut and relief outlet (60MPa above specifications directly exported and head), connecting copper pad applied at the seal. (4) Install the pressure gauge. (5) with a high pressure hose to pressure test the pipeline pressure relief and check valves, connecting copper pad applied at the seal. (6) installed water piping. 2, use: before (1) preparation of a pump installed in a horizontal position so that the oil tank can fully lubricate various parts of the high-pressure pump deceleration check whether there is enough oil tank, oil reached oil standard midline, lubricants No. N46 machine oil (or 40 # mechanical oil). b. Remove the protective cover the front cabinet, check for loose screwed each piston, compression packing plugs, to avoid a collision during the operation, cover protective cover. c. Check the starter motor and electrical insulating portion meets code requirements. For the safe use of electricity, the machine must be grounded. d. Set a clean water reservoir and ensure sufficient water supply. The inlet filter into the reservoir, notice the screen may not be out of the water, in order to improve the life of the pump and its annexes, it is recommended to use the media as much as possible clean, clean. e, moving the pulley by hand to check whether the other transmission parts fresh phenomenon.