2.4G Wireless Dimmer, Wireless RGBW dimming, WiFi dimming tune the color temperature

Product description: a product image II. Remote control Technical parameters 1. Case Material: ABS 2. Process: UV Varnish 3. Power supply voltage: 3V (2 AAA batteries) 4. transmitting frequency: 2400-2483.5MHz 5. transmit power: + 6dBm 6. Modulation : GFSK 7. Remote Control Specifications: 110x52x20mm III. Remote Operating Instructions 1.- lights key, short press to open all of the lights (to maintain the brightness of the last lights), long press for all the lights brightest lights 2.- key, short press to turn off all the lights, press for all light darkest (Nightlight brightness) 3.- dimming plus key: Short press to increase light grade smooth, long press Promise raised 4.- smooth dimming down key: short press for a light grade smooth cut, press stepless down to 5.- warm white keys: Short press graded smooth gradient warm white light, long press Promise smooth gradient white warm white 6.- key: short press for a light grade smooth gradient is white, long press Promise smooth gradient white 7.- packet switch lights key, short press to turn on the lights (to maintain the brightness of the last lights), long press the brightest lights; short press to turn off the lights, press the light darkest (Little Night lamp brightness) Note: Dimming plus and minus keys and plus and minus keys to adjust the color temperature in order to adjust the group key after being operated on or off button, such as the operation is always the power button or the total shutdown button can operate on all the lights. Four. Learning code Operating Instructions 1. code and grouping: The remote control requires the controller to operate after the code can be used, as follows: The remote control lights installed up, the power is connected properly completed, the selected packet control required lights, cut off After 10 seconds, reconnect the power supply, turn on the power at the moment (within 3 seconds) press the corresponding button for 3-5 seconds, set to open, the lights will "; flash three times"; confirm the match and the packet success. Repeat these steps until all the lights desire packets packets