Underground Garage parking dash dash dash basement parking

Ding far to undertake professional road marking, hot melt marking, hot melt marking, parking dash, factory crossed the road, parking dash, crossed the underground garage, school crossed the road, living quarters and other construction crossed Name : parking dash, crossed the road, road marking, parking dash Color: white, yellow (other) parking Specifications: 5000 * 2500 * 150mm crossed Specifications: width 150-300mm Material: crossed special paint (cold paint, hot melt) Cold Paint the construction process: 1, the use of special road for cold paint coatings, artificial spray, thickness, color and clarity. 2, cold lacquer coating is mainly used for parking, roads, road marking special, dried speed block easy to use. 3, night lights under the irradiation, a good reflective effect of acts. 4, prohibiting construction in wet and frozen ground, the temperature should be above 5 ℃ and humidity below 80% Construction 5, the construction using cold painted, cold painted with fast-drying, clear, vivid, iconic good; high mechanical strength film, weather color retention and washable good; strong adhesion, durable wear; with a strong acid and other chemical corrosion. 6, brush or roller construction method, applied 2 times. With special diluent against the thin, thinner dosage should be controlled at about 5% in order to ensure that the thickness of the film. Conventional thickness of 0.2 ~ 0.5mm. Melt construction process: 1, reflective hot melt marking, paint glass beads, petroleum resin hot melt coating. 2, the paint on the inside hot melt machine heated, melted temperature control between 180 degrees to 220 degrees Celsius, and stir for about 10 minutes after coating. 3, mark the location and measurement, according to the design icon next position and graphics, and then labeled primer paint coated figure 4, the hot melt coating can be carried out after the primer dry, the painted markings while spreading reflective glass beads, increase visibility even at night, marking the thickness of 1.5- 1.8MM. Crossed the road is divided into: hot melt marking, scribing cold paint, hot melt oscillation crossed. Hot melt marking of road reticle is most widely used as a scribing process. Advantages construction time is short, high abrasion resistance and low cost. Crossed the road pavement, withstand sun and rain, snow ice, wear a hit vehicle, thus its performance, there are strict requirements. First requires drying time is short, simple operation, in order to reduce traffic disturbances; second, require highly reflective ability, bright, reflective of the strong, so that during the day, have a good visibility at night; and third, should have skid resistance and abrasion resistance, in order to ensure traffic safety and service life. Crossed the road, road marking, the factory crossed the road, the factory parking lot, underground garage crossed, school crossed the road, living quarters and other construction projects crossed, crossed into two crossed cold and hot melt paint. Use Special road for cold paint, artificial spray, thickness, color and clarity. Parking included, Jinting yellow line area, the channel line, the diversion with the guide arrows.