Shenzhen brand air conditioning maintenance and installation company, air conditioning installation price, Nanshan District Government conditioning installation

Select the air conditioning installation location: air conditioning installation site surface should be robust, with sufficient carrying capacity. Must pay attention to the quality of air conditioner bracket, try to use the new stents, stent avoid aging, out welding cause security problems. Air conditioning unit away from heat sources. The indoor unit can not have obstacles out of the top outlet, otherwise the air conditioner is running will affect the air conditioning cooling effect. Going with the flow, the air conditioner drain installation height should also be noted that it is the height of the indoor unit is installed higher than last Drainage Department. If you need to pass through several walls to install air conditioning, then the location of air holes on each wall should also be followed by decline, so drainage is more smooth. Air conditioning ducts, connect the line 1, one end of the split floor-standing air conditioner connecting pipe welded threaded pipe, easy to bend when installing the indoor unit, it can not be misused. 2, together with the cable connection pipe, drain hose bundled together and determine a good connection with the indoor unit length of the distance. With dressing to evenly wrapped, wrap direction by the outdoor unit to the indoor unit bandage to prevent rainwater from entering the pipeline and affect pipe insulation mild. 3, good will wrap pipes and cables through the hole through the wall into the room, and to prevent damage and sediment into the bell connecting tube. 4, the outdoor unit's shut-off valve should be completely closed, when the connection from the shut-off valve at unscrew the nut, connected to the bell immediately (within 5 minutes). Air in the takeover before applying refrigerant pipe out. When connecting pipe to the indoor unit is connected, first pick the low-pressure pipe, followed by high-pressure pipe. When the takeover, the first high and low pressure pipe start slowly, to avoid flattening the tube, banging. Then the connecting pipe and fittings in bell the same line, determine the center of the two joint body alignment, hand tighten the nut in the end portion is connected, then the torque wrench to tighten. 5, connect the indoor unit, should be bent shaping, and then connect the outdoor unit, and be careful not to bend the flexible tube back and forth for more than three times, bending radius should be as large (not less than 10cm). 6, when connected to the outdoor unit, the refrigeration oil evenly on the two, three-way valve joint and the bell, and then align the second bell, the central axis of the three-way valve, hand tighten the nut in the end portion connection , then the torque wrench to tighten it. 7, open the indoor and outdoor unit junction boxes, power lines and signal lines required to connect the condemnation, when the bare wire is fully inserted and then use screw clamp. 8, after the completion of the work, should be re-shaped connecting pipe, as required, fixed, preferably at intervals of 1.5 m at a fixed tube card, to prevent noise while the machine is working. 9, after inspection leak point, the indoor unit and piping connections with black insulation sleeve to wrap up, and then dressing evenly bandaged.