High elastic waterproof rubber non-curable coating

I. Introduction Extension of TD-FGH-component non-curable liquid rubber waterproofing materials, always keeping a viscous state, adhesion, fatigue resistance. In building construction, the membrane interlayer has a certain flow resistance, is a highly effective waterproofing materials, also available as a separate waterproof materials or with ordinary polypropylene polymer membrane-assisted applications. The main raw materials of the product as a special additive. The additive for the production of the waterproof coating core technology, from all kinds of waste rubber to fully extract the active ingredient (such as carbon black, natural rubber, SBS, antioxidants, etc.) and makes the formation of chemical bonding between various polymer, thereby improving the Non-cured rubber waterproof coating stability. Second, product characteristics 1, high solid content solids content of 99.9%. Neither water nor solvent-based coatings milk waterproof coating is no need for a film of the final coating. 2, after the construction of permanent non-cured product, remains elastoplastic jelly state. Throughout the life of the permanently preserving performance, not aging. 3, the magic of self-healing can repair their own damaged due to an external force. 4, strong creep resistance and membrane composite use, even if fully adhered, but also to achieve the effect of empty shop. 5, high and low construction of barrier-free construction to adapt to high and low temperatures, minus 20 ℃ to 40 ℃ can be zero on construction. 6, channeling excellent water resistance and grassroots microscopic full bonding, plugging the pores and fine cracks, a real skin waterproof 7, bonding performance with good adhesion virtually any material. Even in the absence of clear water, wet grass, bonding capacity is also affected. 8, excellent weather resistance and air long-term exposure is not cured, the same performance. 9. Construction Method diversification of the same material, but also you can spray coating, grouting, integration is good. 10, from grass-roots resistance to cracking deformation, subsidence cracking caused by external forces. Third, non-curable pre-construction preparation: 1, significantly uneven grass surface with cement mortar smooth advised: waterproof layer through the conduit, embedded parts, equipment foundations, etc. should be buried in front of the waterproof layer construction and installation. Westerly application between piping and structure of fine stone concrete or polymer waterproof mortar block strict. 2, the base surface should be waterproof construction through grass-roots acceptance, acceptance of the grassroots should be smooth, firm, drainage slope meet the design requirements, the grassroots can be moist, but not have clear water. 3, waterproof construction ambient temperature of -10 ℃ -35 ℃. Rain, snow, wind above 5 is not suitable for waterproofing construction. 4, yin and yang angle, plane and corner of the facade should be wiped into the arc, arc radius appropriate for 50mm. 5, spray construction workers to enter the site should be equipped with appropriate protective clothing, protective eyewear, filtration masks, grouting plugging the operator should do security. 6, construction equipment preparation (1), clearing the grass-roots tools: brooms, hair dryer. (2) construction equipment: special equipment (with spraying equipment, knife with a squeeze pump), conveying pipe, gun, ax, blade, block cloth, tape, etc. (3), Stones roll tools: CD riving knife, roller, surgery. (4), grouting plugging equipment: ① injection pump should meet the uninterrupted continuous feed, to meet the structural hole depth 2m, grouting pressure 0.1mpa above. ② Drill Specifications: diameter 10-18mm, rod length 300-1500mm. 7, the role of conditions: ① electrical connection equipment ready, press the power consumption of equipment required by the field of professional electrician electricity connection and confirmation before construction. ② special equipment before commissioning, construction should be checked at each component connection and debug.