Small mill plant, www.zzhyjq.cn, Shanxi small ball

 When the ball mill gear failure, manifested as Ball Mill speed is reduced, but the real power has increased. After analysis, a lifting power decreases small grinding mill, then this part of the increase in consumption must come from increased friction power. This increase is partly due to the friction between the hollow shaft and the spherical bush increases caused. When the power supply voltage is reduced, due to lower motor output shaft speed, so the dynamic pressure between the hollow shaft and the spherical bush lubricated condition is damaged, and therefore lubrication between the hollow shaft and the spherical bush by the hydrodynamic lubrication into a boundary film lubrication Small mill plant, the coefficient of friction will be greatly increased. This allows the power surge, more than the safety factor of the entire drive train design. Thus, resulting in flexible plastic block coupling rubber block is broken. Thus, the main reason causing plastic pieces are broken due to increase in power, and the power increase was due primarily to lower the supply voltage. Mill equipment inquiries please call contact picture on us, let us win-win cooperation, and seek common development! The main difference between continuous and intermittent ball mill first is that it is a continuous feed and continuous discharge, while intermittent downtime mill loading and unloading stop, thus continuous ball mill has a higher efficiency. If a station capacity of 100 cubic meters of continuous ball mill, the raw material for the production of ordinary ceramic tile production up to 300-360 tons / day, the equivalent of 30 tons of Taiwan 7-8 mill batch production, this can only saving 20% about. Continuous slurry discharged from the mill is turning mill, ball mill intermittently discharged from the mill still mud. The longer the agitation time, the smaller the viscosity, still longer buy a small ball, the greater the viscosity, and therefore under the same conditions from turning mill mud released than from the rest of the mill discharged mud viscosity is low, therefore continuous ball mill slurry water content can reduce a lot better than intermittent ball mill. Such a low water content of the slurry water during the milling of the spray-drying tower need to reduce evaporation, heat required is reduced, thereby reducing energy consumption. Also, out of the mud from the continuous ball mill is only a short stay in the mud pools can be directly fed to the spray tower milling, so when the mud temperature is higher not only conducive to the atomizing nozzle and reduce the supply of heat, which in turn is its energy-efficient the reason. Equipment for inquiry please call Tel picture, we will be happy to help you!