Waterproof polyethylene fiber plant, four blessing metallurgical material (certified), polyethylene fiber waterproofing

Waterproofing membrane construction: The base inspection and acceptance. Substrate requirement surface is dry, its moisture content should not exceed 8 percent as required, or by covering the adhesion test. Requested surface should be smooth, the basic level hard, does not appear from the sand, cracks, loose, from the dark, inequality. Smooth surface inspection should be 2m long ruler to check polyethylene fiber waterproofing, ruler and grassroots gap should not exceed 5mm polyethylene fiber waterproofing manufacturers, allowing only gradual change polyethylene fiber waterproofing brand, not more than one per meter length surface no water Anyang polyethylene fiber waterproofing, drainage slope should meet the design requirements. Construction waterproofing membrane: primary treatment. Before construction should be carefully cleaned the surface of base on residual cement mortar residue, dust and debris, then brushing the bottoms, requiring brushing uniform, a good coating, drying above 8h (in temperature may be, sticky foot appropriate ) is generally used in an amount of 0.2 per square meter to 0.3kg. Waterproof polyethylene fiber plant, four blessing metallurgical material (certified), polyethylene fiber waterproofing provided by the Anyang County four blessing metallurgical material limited liability company. Anyang County, four blessing metallurgical material limited liability company (www.4fyc.com) Henan Anyang, waterproof, moisture-proof material leader, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs . Fu metallurgical material in the four leadership with the staff warmly welcome all inquiries negotiations to create the four-fu metallurgical material better future.