Authentic power of the whole AR-992A precision grinding machine pen, wind mill pen, trimmer

Name: AR-992A pen grinding machine, the wind mill pen, engraved pen mill, wind mill, trimming machine, engraving machine. Speed: 60,000 rev / min Chuck: 3m / m 1/8 "3/32" Air consumption: 90 / PCI Dimensions (mm): φ18 × 170 (L) Weight: 140 g small deep hole machining grinding back and forth motion After discharge surface irregularities corner grinding is especially good, use emery cloth surface height job express, in particular, the use of a diamond knife to play fast, super Whetstone has especially good effect. Safety specifications before [] (1) the use of pneumatic tools, make sure you finish reading this parts manual, and only after a complete understanding, in order to use pneumatic tools in the workplace and the need to strictly enforce it. [Letter] Do not exceed the maximum operating pressure (100PSI / 7.0BAR / 7.0kg / cm2) when using the tool often makes pneumatic tools work in excess of the operating pressure of the environment, will greatly reduce the life of the tool itself. (2) Please remove the pneumatic tool from the air at the source when changing tools or accessories. (3) operation possible wear goggles earplugs. Respirator in order to safeguard its own security. (4) Do not wear loose clothing when operating. Scarf tie or jewelry, to avoid being involved in moving or rotating parts and dangerous. (5) When the pneumatic tools and high-pressure gas source is connected, when not in use, do not press the trigger. (6) at any time to ensure that spare parts situation, loose parts may cause serious danger. (7) Replace worn parts, use the special parts. (8) Do not use pneumatic tube damage or impact. (9) Do not the tool at yourself or others. (10) The use, check if there are more vulnerable pneumatic tube or breakage of the Department, if found that the above situation, please update immediately, in order to maintain security. (11) Tighten all nuts, screws, and make sure all equipment is in a safe state. Moderate tool lubrication is responsibility of the user. Compressed air will condense water vapor, could easily lead to corrosion if there is no appropriate lubrication will greatly shorten the life of pneumatic tools. [Note] pneumatic tools before and after use is required to be lubricated. Part of the air motor lubrication - air motor lubrication daily needs, but not too many times. [Letter] Please before lubricating the tool from the high pressure region air source unplugged. (1) Unplug the tool from the high pressure area. (2) pressing the trigger while adding 3 ~ 5c.c pneumatic tools for oil from the intake head. The tool connected a high pressure air source, and cast a rag or towel in the vent. Start tool, positive, reversing each 20 to 30 seconds, when the high-pressure gas connected to the operation, the lubricating oil will be discharged from the rear vent. Shock frame part of the group lubrication (butter) Impact frame group require lubrication once a week for maintenance. (1) Unplug the tool from the air line. (2) before the removal of the screw cover (or front cover immediate release) Wash the butter on the inside of the front cover and the residual impact rack group. (3) On the impact rack group Apply a proper amount of butter, and then lock the front door. (4) connected to the pneumatic tube, gently start trigger idle for 20 to 30 seconds for the entire impact grease lubrication unit. [Note] (1) Do not split over the need to repair or replacement of parts during disassembly. Be careful when (2) Working avoid any tools or damaged. (3) When removing the impurities can not enter. [Service] Where the guidelines Division I sold all the tools, we will commit to three months warranty and lifetime maintenance, normal supplies are not covered under warranty, proven son is my driver, maintenance not charge any service fees charged only For parts of the cost, the proposed buyer to call us, electricity prices! We will make every effort to meet your needs. If you have questions, please contact customer service