Hydraulic lifts 6 m | Baise Hydraulic lifts | Jinan Jinsuo faithful

Safety Rules 1. allowed as lifting people ladder platform and hydraulic lifts prices fall injury prone event. 2. must not overload to use, can be used only on a smooth, level firm ground hydraulic lifts 6 meters, especially with the ground pits, obstructions, unstable environment. If not pay attention prone to turn to the injury. 3. cargo carrier to the right place on the fork is not allowed weightlifting partial load. If not pay attention prone to collision damage. The operator uses the van should wear safety shoes and gloves, your hands and feet carefully operating the van under the forks. Little attention prone to injury. 5. Use the van, careful not to use faulty, damaged machines; thoroughly inspect each finished using vans fault hydraulic lifts, eliminate all kinds of problems, to avoid damage to the machine malfunction. Hydraulic lifting platform should be how to maintain the wheel, the intermediate shaft and bearings, cylinder pin and bearing, boom hinge shaft and bearings for wear. Hydraulic lifting platform various parts are filling some of the oil, extending bearing life. Oil and oil level of the hydraulic oil. Lifts full rise, at this position, hydraulic ground should be higher than the bottom 40 to 50 mm. If found hydraulic oil darken, sticky or gritty and other foreign matter, it should be replaced (32 # hydraulic oil). Check all hydraulic lines and fittings. Pipes can not have broken, can not have loose joints, all joints must be tightened. Remove and open the lowering valve hydraulic elevators video, using compressed air to blow out the plunger, then loaded reattach. Discard exhausted hydraulic fluid, tighten the fitting Remove the oil filter, after cleared with compressed air to clean up, and then back into the tank and connected piping. (Replace with new oil, do not continue to use the old oil otherwise the system would accelerate the wear of moving parts.) Hydraulic lifts 6 m | Baise Hydraulic lifts | Jinan Jinsuo faithful Jinsuo provided by Jinan Machinery Manufacturing Company Limited. Jinan Jinsuo Machinery Manufacturing Co. (www.sdjinsuo.com) (www.yuhangjixie.com) strong, credible, in Jinan, Shandong hydraulic machinery and components industry has accumulated a large number of loyal customers. The company better work attitude and constantly improving innovative ideas will lead Jinan Jinsuo machinery into the brilliant and you work for a better future!