Yunnan three return dryer, Ming-mechanical (certified), three return dryer

 Zhengzhou Ming sand drying process equipment will be introduced 1 disc feeder: are open disc feeder, sand can be well controlled feed rate and to the quantity, and the entire process to ensure uniform feed , thereby extending the life of production equipment. 2. Conveyor belt: the entire process multiple use conveyor belt, is the interface between tools and equipment, to ensure complete drying process sand indispensable tool. 3. Stove: If you are coal, wood and other fuels, then, after going to burn in the stove, the heat generated inside into the host, play a role in the supply of heat. 4. quicksand tube: through the upper part of the device from the stove, enter into the host, is fed into the host sand dry transfer apparatus, the size of quicksand tubes on the final production also plays a certain influence. 5. receiving hopper: installed in the host's spout, is divided into two channels, the upper impurity for dust emissions and lower emissions for the material after drying, played the role of controlling the material. 6. Cyclones: dust contaminants through a pipe into the cyclone, after hitting the wall fell, play a role in collecting pollutants. 7. The linear shaker: able to sand after drying was sieved to give the final desired material. 8. Hoist: the ability to elevate up the sand, and placed at the lower outlet bags three return dryer works, reducing labor, easy bagging. 9. Exhaust Fan: This device can generate heat stove fuel pumped into the sand dryer inside the host, and materials to make contact and heat exchange. Three-pass dryer - operation and maintenance of a dryer, the drying efficiency of the dryer level, depends largely on the quality of the combustion chamber, and therefore, during operation of the dryer, a combustion chamber must, blowers and dust cleaning equipment to be special attention. 2, one hour before starting the dryer stove ignited three return dryer technical parameters, check all ancillary equipment, including various transmission part of Hubei three return dryer dryer, support dragging part, etc., should be tightened normal, slippery, reliable before driving. (A) should be checked before lighting the stove stove, furnace grate, feeding equipment, combustion chamber, furnace slag pit, door, air ducts, control valves and blowers, dust and so on. Should check the fuel, tools, gear carrier means all lubricated bearings and friction surfaces before (two) open the dryer. (C) step is to start the dryer to start the drying machine motor, after starting the wet material transport equipment, transport equipment and then start the dry material to form a continuous and uniform operating procedures. 3, in the dryer during operation should always check each part of the bearing temperature, the temperature should not exceed 50 ℃ three return dryer, gear noise should be smooth, transmission, support care and barrel swivel should be no significant impact, vibration and drive, you should also do regular checks of equipment, maintenance and repair work, which should include: (a) all of the bolts should not have loose fasteners. (B) should always pay attention to the case of rolling contact ring and gear wheel tugs. (C) wind ring gear cover should not have hit the wing crack and friction loss situation. (D) The following table shall be carried out in different parts properly lubricated. Yunnan three return dryer, Ming-mechanical (certified), three return dryer will be provided by the Zhengzhou Machinery Co., Ltd. Ming. The Ming Machinery Co., Ltd., Zhengzhou (www.zzmjjx.com) is Zhengzhou, the other leaders, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. In the Ming mechanical leadership with the staff warmly welcome all inquiries negotiations to create the mechanical Ming a better future.