Stainless steel peeling machine

Note: 1. Place the machine on a level of the workplace, ensure that the machine below the legs smooth, reliable, does not shake carefully check whether the debris rotating barrel, if the foreign body clean, so as not to cause damage to the machine for each. parts seized drip. fasteners are loose in use, the switch circuit is broken. 2. To ensure safety, the mark must be grounded in the ground, the power adapter must be installed leakage protection! ! ! 3. When the machine is working, non reach into the machine, in the process do not press the switch with wet hands. 4. Before carrying out clean-up removal, first disconnect the power, the machine stops. 5. Bearing every three months to replace a second calcium-based grease. 6. During use, if unusual circumstances, should quickly turn off the power switch, restart After troubleshooting, make it work properly. Instructions: 1 power, start switch, to see whether the direction of rotation of the cylinder and dial reel spin the cylinder cover as the arrow rotation consistent, otherwise the three-phase power in any two-phase reclosing can be swapped with with the water hose to the intake port switch is turned on, the sewage discharge hose can be connected according to the situation, put the container or directly to the sewer drain. 2 After starting the machine, put the potatoes from the flap, 350 every 10-15 kg is appropriate. 3 Turn the water switch, turn on the water to spin the cylinder, appropriately adjusted volume, the compression cylinder cover, the start switch. 4 machine for about 2 minutes or so, turn off the power switch and the water switch, depending on the potato peeling, the skin if the potatoes have been off the net, you can open the cartridge door, turn on the power switch, the potato in rotating dial push reel from the cylinder automatic door unloading.