Longyan distributor in the United States TAYLOR sterile saline ice machine factory direct supplier Spot

Longyan distributor in the United States TAYLOR sterile saline ice machine factory direct supplier stock Xiamen Haichen Chak Instrument Co. Model 20N-40 ice machine is used to produce a soft, non-stained ice spikes mud The ice slurry is to meet the needs of the surgical procedure. Ice is determined by the amount of mud surgeon, ice mud once the maximum amount of 6,000 ml. The following steps show you from the boot device to produce ice mud the whole process. Also be sure to follow all disinfection procedures standard hospital disinfection. 1. Plug in the power cord, 220V supply voltage. 2. Press the control switch, press pass power. At this time the red light. 3. Add the heat conduction medium (capacity 1200ML-1300ML) to insulated steam room, thermal conductivity media by the hospital of their choice. The media must meet two conditions: ① has good thermal conductivity. ② at -32. 7 ℃ will not freeze. 4. suggested the use of 50% ethanol with water. Before adding coolant when added after the media need to set the heat conduction cooled for 15 minutes. 5. After setting cold sterilizing conditions to sterilize the cloth cover on ice machine, put the lid on the insulated bag sterilization steam, but do not cover up the louvers. 6. sterile conditions and gently sets have been sterilized and disinfected ice bag into steam pots wells. 7. adding 1.4 liters of saline into the pot, in order to shorten the freezing time, require pre-cooling the brine to 4 ℃. 8. After 15 minutes later, when the melting ice formation, with onboard polycarbonate shovel (rigorous disinfection) for melting ice, until the formation of the desired ice mud. If not used immediately, the ice slurry is frozen on both sides of the basin, once this happens, with a shovel formed ice slurry again stirred until ready for use. 9. Ice mud after use if needed, can be added as appropriate, the right amount of saline, repeat the above steps. If not, turn off the power, clean up the pot waste. 10. put a drain on medical Xiaopen, the drain is located in the lower right corner at the bottom of the ice machine, hand drain valve loose central steam room until all the heat exchange fluid drained to minipots until finally the drain valve tighten. 1. Ice Ice machine integrated parameter basin, contained about 6 liters capacity, easy to move, easy to disinfect. 2. The one-touch control switch. 3. agitator by wear-resistant plastic, can be sterilized or high-temperature gas sterilization. 4. freezing point at -37 ℃. 5. Ice mud once the largest amount of 6000 ml. 6. Power Requirements: 220V / 50HZ / 1 phase 7. Dimensions (W × D × H): 448 × 419 × 914