Guangzhou Les LS-F20W fiber laser marking machine imported German IPG Laser Marking Machine

Laser marking machine marking lines, sometimes bending laser marking machine marking out lines that sometimes curved lines, sometimes inattentive to see if a small bend, are generally not easy to find, especially when playing some big fonts more difficult to find. This requires the user to be more careful of the machine, after marking or do the necessary checks or sampling the job. If allowed to continue because of this phenomenon, laser marking machine might a whole lot of problems, especially marking the first part of the question galvanometer. This is the actual galvanometer sick. Direct cause of laser marking machine appear curved lines are galvanometer inaccurate positioning, and there are phenomena shake. Galvanometer positioning caused inaccurate jitter of what the underlying causes: 1, laser marking machine galvanometer control external interference signals, such as signal lines not connected signal ground and the earth; and Q signal line drive by large RF line nearly there interference, this interference can be turned off while checking out the Q drive; the signal line is damaged, such as shield damage, etc. Cause 2, laser marking machine galvanometer itself is a problem, galvanometer potentiometer or capacitance Or other components or bad values ??have changed: the motor out of the question; the motor and motor frame did not do insulation. 3, laser marking machine marking card, the main problem is a problem with the card on the DA, DA card adapter does not work, or the calories out of the question. 4, laser marking machine computer problems, software is not installed, the drive is not updated, the driver did not install the full, inside the computer has a virus and so can cause.