Heze waterproof coating waterproof mortar sealing agent

Product Features: This product using advanced technology formula, a modified high-performance synthetic inorganic polymer emulsion and dry powder mortar mix according to scientific compound formed. Non-toxic non-corrosive, environmental compliance, can be directly used for drinking water pool. Usage: JS-1 polymer cement-based waterproof coating: mainly used to make the roof waterproof layer or a higher performance of the occasion to extend a waterproof coating. JS-II polymer cement-based waterproof coating: mainly used for basements, underground tunnels, bathroom, pool, etc., especially under wet and construction of long-term immersion in water conditions. Construction process: (1) the base surface treatment: the base surface must be flat, solid, clean, no clear water, no leakage. Must first leveling uneven Department; plugging leaks must be treated quickly recommended sealing agent 901, 1000; Yang angle should be made of the arc angle. (2) Ingredients: reclaimer according to a predetermined ratio, thoroughly stirred with a stirrer for about 5 minutes, until the compound free of agglomerates, preferably without manual stirring. Primer layer coating, etc., For water, the first compound in the liquid water is added slowly while stirring with a stirrer was added powder. Increase the amount of the color pigment layer coating liquid material is 10% or less, and only need to add a pigment in the surface layer coating. (3) Finish: According to the characteristics and requirements of the project, select the appropriate construction methods. Even when applied to try, you can not have local deposition and require more brush a few times so do not leave the bubble between paint and grass-roots, tight bond. When used on wet or grassroots non-absorbent, did not need the bottom. Before the time interval between the layers to dry non-stick coating layer prevail. If the waterproof layer thickness is not enough, especially in facade construction, you can add one or several layers coated. When adding non-woven construction, painted and coated on to be continuously under construction, woven want Paving straight, and do not stay with a brush real hollowing. Note: 1, not the rain or the construction below 0 ℃, in particular damp unventilated environment, will affect the drying and film. 2, under normal conditions, the coating can be used for about 3 hours, the coating to dry for about 2 to 6 hours. Site ambient temperature is low, humidity, poor ventilation, long time to dry more; conversely shorter. 3, the basic color is ivory white. When you select other colors, plus neutral, inorganic pigments, suggested the use of iron oxide pigments. Other pigments must first test confirmed that no anomalies, before use. 4, to be completed in two days after the waterproof layer. Wipe mortar is to facilitate the construction, in the final again after a waterproof layer coating, immediately sprinkle with coarse sand clean.