Bristol selling scrap briquetting machine S / briquetting machine performance

 Bristol selling scrap briquetting machine system is a motor control circuit and motion control circuit components. (1) scrap briquetting machine motor control circuit: 380V three-phase AC power supply, including power indicator and electric start and stop control circuit to control a three-phase cage induction motor, model Y132M-4, power 7.5KW, speed of 1440 rpm, used as a power source to drive a variable axial piston pump. (2) motion control line: The three-phase 380V power transformer into a 220V power supply, in order to meet the needs of each region. The line has two lines, one to control the shear binder, a controlled return reset. (3) For individual areas without power, you can specially equipped with diesel as a power source, then the electrical system only motion control circuit without motor control circuit. 2. The main electrical components: (1) AC contactor KM model CJX1-22 / 380V, get through the contactor coil, loss of power to control the pull-in auxiliary contacts and main contacts and further to turn on and off, or Disconnect the power to remotely control the motor starting and stopping. (2) relay models were CJX1-12 / 220V and JTX-3C / 220V, the electromagnet was used to control, loss of power, to achieve the purpose of cutting, binder and backhaul reset and form of self-protection circuit in continuous operation . (3) solenoid YV1, YV2 model MFB3-90YC, for wet solenoid valve rated voltage AC 220V, its holding force of 90 Newton. By too, loss of power to control the solenoid valve solenoid valve commutation. (4) switch SA models LA18-22 × 2, for the two knobs for adjusting the mode of operation - single or continuous, the operator can be reasonably selected as desired. (5) button model LA18-22, normally open (or normally closed), push button, normally open contact closure (or normally closed contacts open), on (or off) the power to control a Cut button SB4 movements basis having to complete each time to complete a cut, return movements. (6) continuous motor starts, the SA put continuous operation, the completion of a continuous shear cut, return movements. (7) stop, jog return anomalies found in the work process, press the emergency stop button, shearing machine at any time, any trip interruption, to ensure safety. Such as by heavier, then release, then shears will perform jog return action.