Er Sheng race Supplying SEN-FB21WA over plate flow switch nylon and fiberglass flow switch

SEN-FB21WA over plate flow switch specifications SEN-FB21WA turn flow switch plate, made of nylon and fiberglass, the bearing capacity of 1.2MPa, G1 / 2 (DN15) outside the wire interface, detailed specifications: 61.5 * 42.2 * 27.5mm outer tooth length 10.5mm; horizontal installation, use medium is water, long-term temperature 60 ℃, the output switch signal for traffic detection through pipes inside the case, provided the signal flow through and drying, is a flow sensors, signal devices belong. Start flow of 1.2L / min, off switch flow 1.5L / min (0.05MPa), the error is 10%, the maximum through flow 30L / min; power switch has two optional 10W and 70W, the harness specifications can be customized; switching power and parameters proceed as follows: switching power of 10W, the maximum switching voltage: DC200V, minimum breakdown voltage: DC250V, maximum switching current: 0.5A, maximum load current: 1.0A; switching power is 70W, the maximum switching voltage: DC220V / AC250V, minimum breakdown voltage: DC400V, maximum switching current: 1A, the maximum load current: 1.5A. . Do not use water flow switch direct access to the high-voltage circuits, please use with relays, while the use please install the filter, to avoid the flow switch cards and magnetic flap is adsorbed; shaking and vibration can not be installed in the environment in order to prevent the flow switch malfunction; you can not use in magnetic environments, so as to prevent the flow switch failure; flow switch is a precision instrument, do not open to prevent damage to the flow switch, where the unauthorized flow switches are disassembled Our company is not covered under warranty. If there are puzzled at the selection process please contact our sales staff consultation, before the actual installation flow switch, please read the technical parameters and flow switch wiring diagram.