Production of carbonized charcoal smoke how to deal with? Charcoal, smoke processor

Many people are worried about the mechanism of charcoal production process will not produce black smoke, will not affect the environment? Here are several ways to tell you: The first suggestion is to chimney series, concentrated emissions, popular point that put forward a chimney, the chimney together, concentrated emissions from smokestacks into the air. This method is very simple, low-tech and no cost. Before we then put the video on the website, the chimney that are connected in series, or carbonization kiln furnace smoke through the introduction of a large chimney flue public focus altitude emissions. When using this method requires the initial stage of carbonization and tear down a single connecting pipe between the flue and the common flue, in order to observe changes in the kiln smoke. While this approach does not reduce the total amount of smoke emission, but the emission mate lifting height, so there is still a large extent reduce the impact on the surrounding environment. Is a good workaround, but also a lot of charcoal manufacturers widely used. The second suggestion is that flooding is to let smoke through sedimentation pond. Use charcoal equipment needed to build a pond next to the kiln or furnace smoke carbonized by introducing the bottom fan and piping, due to the large specific heat of water, the water in the kiln smoke in the process of walking its wood tar and wood vinegar rapid condensation of water will be sunk low, a small amount of wood gas discharged from the surface of the water, which can be reduced by more than half of the kiln smoke. It should be noted that the principles of this approach is actually condensed rather than dissolved, in addition to the evaporation loss of the small amount of water, the rest can be used repeatedly. Also in the bottom of the sink sludge must be removed regularly, there are certain technical content. The third proposal is condensate recovery, this method is relatively high input costs, but can be recycled wood tar and wood vinegar This method requires the purchase of equipment, is condensing tower and separation tank. If you want a high-purity wood tar and wood vinegar, need to do a large investment in equipment, for the cost of the general Tanchang This recovery is clearly too high. If you do not have good sales channels, the recovered product and can not be realized, after all these byproducts broad market better than charcoal. Nevertheless, the recovery also represents the development direction of the industry, if you can reduce the cost of recovery, which should be the best solution. The fourth panel parts are electrically operated, its thickness should be greater than or equal to 2 mm, charcoal equipment front propeller levers should solder alloy rods and spray alloy powder, ground smooth as required to meet the design and taper angle requirements. The fourth suggestion is repeated burning, the main component of wood tar and wood gas kiln smoke have flammable, but because of the kiln oxygen-depleted environment, so it can not burn. If you can smoke at the crossing with the small amount of fuel to be ignited, the degree of pollution will be greatly reduced. However, this method is subject to weather conditions. There is a big fire hazard. Also try to introduce the smoke chamber kiln dryer, as the drying of fuel is also a double benefit solution. Many Tanchang attempts have been made in this regard, but there are gains.