Dow Corning 3145RTV

Dow 3145RTV 90ML transparent semi-mobile / gray UL, MIL approved, high temperature, for display parts fixed, then. The main purpose; for terminations / solder junction with good coverage, a thin layer of sealing, low stress protective coating hard and soft printed circuit board. Non-corrosive, single-component, self-leveling, solvent-free moisture-curing RTV silicone elastomer; type. Physical state; high viscosity Blanchir / translucent liquid. Characteristics; heat accelerated cure moisture resistant translucent good dielectric properties other harsh environments. Temperature range; -55 ° C ~ 200 ° C. Use; dispensing dipping and basting brush. Special shelf 1-2577,1-2577 LOW VOC, 1-2620,1-2620 LOW VOC, 3-1953,3-1944, PelGan Z, SE9168, SE9176, SE9176L, SE9186, SE9186L, SE9187L, SE9188, SE9189L, 3140,3145,3165, EA-4100, EA-9189,732,734,737,739,7091,160,170,184, CN-8760, CN-8760G, SE4420, SE4450, SE4485, SE4486, Q1-9226, TC-5021, TC-5022, TC-5026, TC-5121, TC-5625, SC102, CN-8880,340, DC7. Silicone moisture insulating protective film containing solvent-water oil (1-2577,1-2577LV, 1-2620,1-2620LV, PELGANZ), solvent-free insulating oil (3-1753,3-1744,3-1765,3 -1953,3-1944,3-1965, followed by room temperature curing silicone caulk, pure neutral, off alcohol, illiquid (SE9168, SE9188,3145,3165,739,7091, room temperature curing, acid, illiquidity (732,736), room temperature curing, acid, liquidity (734), room temperature curing, off oximes, illiquid (737,735,9590, EA-4100), heat-curing (Q3-6611), room temperature curing, pure neutral, off alcohol, liquidity (3140, SE9176L, SE9186L, SE9187L, SE91), low stress perfusion package casting silicone gel (527), a soft elastomer (SYLGARD160,170,184, CN-8760, CN -8760G) thermal insulation silicone-drying, paste thermal grease (TC-5021, TC-5022, TC-5026, TC-5121, TC-5625 Curing, thermal plastic elastomer (SE9184, SE4420, SE4450, SE4485 , SE4486, EA-91), high vacuum seal fat, grease HighVacuumgrease, DC7, glass curtain wall construction sealant glue: 791,995, SJ168, fluorocarbon lubricant (HANARL), epoxy resin (single liquid type): 2214 , moisture-curing hot melt adhesive: TE-100, TE-200, TS-230