Professional stickers | stickers | sticker printing | adhesive labels machine maintenance

 Labeling machine types are: self-adhesive labeling machine, sleeve labeling machine, labeling machine, beer labeling machine, semi-automatic labeling machine, labeling machine, automatic labeling machine, automatic labeling machine, labeling machines, self-adhesive labeling machine, hot melt labeling machine and so on. The plane paste labeling machine can be completed, the packaging of single or multi-surface paste, paste cylinders, partial or full coverage of the cylinder cover and paste, paste and so depressed and wanted to corner site labeling machine life longer, So we have to take care of the labeling machine, but also pay attention to some maintenance issues labeling machine. Labeling machine maintenance tips: 1. Brush pressure adjustment device. Brush the center mark and label both sides are symmetrical. Standard brush perpendicular to the container surface. Pressure vessel overlap sweep brush clearance: single pressure brush is 10mm ~ 15mm, the combination brush pressure is 5mm ~ 10mm. Cleaning sponge brush away from the location of 1mm ~ 2mm. Pressure bottle adjustment head. Bottle head pressure should be lower than in the absence of the bottle when the bottle 20mm. 2. The cassette of adjustment. Centerline marked boxes marked with labels station central axis tangent, standard plate center axis of three in a line, adjusting the standard plate and labels tangent (0 distance), then the standard boxes closer to 1mm ~ 2mm. Standard paper cassette with both sides of the gap marked layering should be between 0.8mm-1mm gap caused by too much paper in the standard box marked shift appears oblique mark, the gap is too small will cause poor standard push. Standard boxes marked grab hook position adjustment: up and down, left and right hook caught marked on the same vertical plane and even difficult for standard paper, you can successfully catch mark. Label feed roller adjustment: no tag when the tag plate can be pushed to the forefront of the cassette and when fitted with the label, the label refers to a label near the hook can not be crushed. 3. star wheel into the bottle, the bottle star wheel, adjust the auger into the bottle. When the intake, the bottles into the bottle screw star wheel and lever can be adjusted to the pressure bottle header machine prevail. First, adjust the star wheel into the bottle when the bottle head just overwhelming pressure bottles, adjust the star wheel into the bottle, the bottle in the middle of the star wheel groove. Infeed auger adjustment: the infeed star wheel prevail into the bottle when the bottle is located in a groove in the middle of the star wheel, adjust the auger, the auger into the bottle so that the side of the bottle, but do not try to be displaced. Adjust the star wheel out of the bottle: when the pressure bottle head just raised, adjust the star wheel to the bottle in the middle of the groove star wheel. 4. adjust standard station. Scratch sheet adjustment and rubber roller: scrape board and cots can not occur over the entire length of the gap, if there is a gap can be adjusted by adjusting the eccentric bolt scrape board. Cots and standard plate adjustment: between the target board and cot only contact with each other without any pressure. The gap is too big, too much glue on target, resulting in rejection of glue. The gap is too small, too tight contact, will squeeze the glue, no glue marked half board. Practice has proved that standard plate and rubber roller gap between 0.1mm ~ 0.2mm for the best. You can adjust the lower bearing rubber roller to achieve, on the upper part of the rubber roller bearings adjusted if necessary. Telephone [micro] Letter: 18926979246 QQ: 2901223865,2563008963 Alibaba: http: //shop1404838286676.1688.com/